Page 56 / 64
Scroll up to view Page 51 - 55
SSG 5 Hardware Installation and Configuration Guide
56
±
8. Eth0/1 Interface (DMZ Zone) Window
The DMZ interface can have a static or a dynamic IP address assigned via DHCP.
Insert the necessary information, then click
Next
.
Figure 27:
Eth0/1 Interface Window
Table 16:
Fields in Ethernet0/1 Interface Window
9. Bgroup0 Interface (Trust Zone) Window
The Trust zone interface can have a static or a dynamic IP address assigned via
DHCP. Insert the desired information, then click
Next
.
The default interface IP address is
192.168.1.1
with a netmask of
255.255.255.0
or
24
.
Field
Description
Dynamic IP via DHCP
Enables the device to receive an IP address for the DMZ interface
from a service provider.
Static IP
Assigns a unique and fixed IP address to the DMZ interface. Enter
the DMZ interface IP address and netmask.
Page 57 / 64
±
57
Figure 28:
Bgroup0 Interface Window
Table 17:
Fields in Bgroup0 Interface Window
Field
Description
Dynamic IP via DHCP
Enables the device to receive an IP address for the Trust zone
interface from a service provider.
Static IP
Assigns a unique and fixed IP address to the Trust zone interface.
Enter the Trust zone interface IP address and netmask.
Page 58 / 64
SSG 5 Hardware Installation and Configuration Guide
58
±
10. Wireless0/0 Interface (Trust Zone) Window
If you have one of the SSG 5-WLAN devices, you must set a Service Set Identifier
(SSID) before the wireless0/0 interface can be activated. For detailed instructions
about configuring your wireless interface(s), refer to the
Concepts & Examples
ScreenOS Reference Guide
.
Figure 29:
Wireless0/0 Interface Window
Page 59 / 64
±
59
Table 18:
Fields in Wireless0/0 Interface Window
After you have configured the WAN interfaces, you will see the Interface Summary
window.
Field
Description
Wlan Mode
Sets the WLAN radio mode:
±
5G (802.11a)
±
2.4G (802.11b/g)
±
Both (802.11a/b/g)
SSID
Sets the SSID name.
Authentication and Encryption
Sets the WLAN interface authentication and encryption:
±
Open
authentication, the default, allows anyone to access
the device. There is no encryption for this authentication
option.
±
WPA Pre-Shared Key
authentication sets the Pre-Shared Key
(PSK) or passphrase that must be entered when accessing a
wireless connection. You can choose to enter a HEX or an
ASCII value for the PSK. A HEX PSK must be a 256-bit
(64-text character) HEX value. An ASCII passphrase must be
8 to 63 text characters. You must select Temporal Key
Integrity Protocol (TKIP) or Advanced Encryption Standard
(AES) as the encryption type for this option, or select
Auto
to
allow either option.
±
WPA2 Pre-Shared Key.
±
WPA Auto Pre-Shared Key.
Interface IP
Sets the WLAN interface IP address.
Netmask
Sets the WLAN interface netmask.
Page 60 / 64
SSG 5 Hardware Installation and Configuration Guide
60
±
11. Interface Summary Window
Check your interface configuration, then click
Next
when ready to proceed. The
Physical Ethernet DHCP Interface window appears.
12. Physical Ethernet DHCP Interface Window
Select
Yes
to enable your device to assign IP addresses to your wired network via
DHCP. Enter the IP address range that you want your device to assign to clients
using your network.
19216811.live