Page 21 / 104
Scroll up to view Page 16 - 20
²·
FR-300RTR User Manual
Sect±on 3 - Configurat±on
If you selected PPTP, enter your PPTP username
and password. Click
Next
to continue.
If you selected PPPoE, enter your PPPoE username
and password. Click
Next
to continue.
Select
Static
if your ISP assigned you the IP
address, subnet mask, gateway, and DNS server
addresses.
Note:.
Make sure to remove your PPPoE software
from your computer. The software is no longer
needed and will not work through a router.
Page 22 / 104
²¸
FR-300RTR User Manual
Sect±on 3 - Configurat±on
If you selected L2TP, enter your L2TP username and
password. Click
Next
to continue.
If you selected Static, enter your network settings
supplied by your Internet provider. Click
Next
to
continue.
Page 23 / 104
²¹
FR-300RTR User Manual
Sect±on 3 - Configurat±on
Click
Connect
to save your settings. Once the router
is finished rebooting, click
Continue
. Please allow
1-2 minutes to connect.
Page 24 / 104
³0
FR-300RTR User Manual
Sect±on 3 - Configurat±on
If you opt to set up your Internet connection manually, you will be redirected to a WAN page that allows you to select
your Internet type and enter the correct configuration parameters.
Select your Internet connection type using the “
My.
Internet.Connection.is”
drop-down menu.
Click the
Save.Settings
button when you have
configured the connection.
Manual Configuration
Dynamic (Cable)
Page 25 / 104
³²
FR-300RTR User Manual
Sect±on 3 - Configurat±on
Dynamic IP Address (DHCP)
Select
Dynamic.IP.(DHCP)
to obtain IP Address
information automatically from your ISP. Select
this option if your ISP does not give you any IP
numbers to use. This option is commonly used
for Cable modem services.
The Host Name is optional but may be required
by some ISPs.
Check the box if you are having problems
obtaining an IP address from your ISP.
Enter the Primary DNS server IP address
assigned by your ISP.
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1500 is the
default MTU.
The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless required by your ISP.
You can use the
Clone.Your.PC’s.
MAC.Address
button to replace the Internet port’s MAC address with the MAC address of your Ethernet card.
My Internet
Connection:
Host Name:
MAC Address:
DNS Addresses:
MTU:
Use Unicasting:
19216811.live