Page 16 / 73
Scroll up to view Page 11 - 15
12
2.7. Wizard Configuration
Click
<Next>
to enter mode selection.
Select the mode that ESR9850 is going to be and set its configurations.
AP Repeater
mode
does not enable WAN interface, Setup Wizard will skip WAN Configuration.
Click
<Next>
to automatically detect your
Internet
Network
settings.
Smart Wizard has detected DHCP client. Configure the host name and MAC address of your
ADSL modem. Click Next to proceed.
Page 17 / 73
13
Smart Wizard has finished setting up
WAN Configuration
. Click
<Next>
to proceed.
Enter the name for your wireless network (SSID) and security key
Click
<Next>
to proceed
To apply the entire configuration, click
<Reboot>
.
NOTE:
After Wireless settings are applied, you need to connect from your WLAN client
with the security settings you just finished configuring. Remember the type of
security & security key.
Page 18 / 73
14
2.8. Initial Setup ESR9850
ESR9850 provides web-interface for configuration through web browser, such as
Internet Explorer, Firefox or Safari.
1.
Open your browser (e.g. Internet Explorer).
2.
3.
Click
<OK>
to navigate into ESR9850 configuration home page.
4.
You will see the home page of ESR9850 as follows.
Page 20 / 73
16
3. SYSTEM
3.1. Status
This page allows you to monitor the current status of your router. You can use the status
page to quickly see if you have any updated firmware available (bug fixes, updates). You can
navigate from this page with a few interesting options for reminding or skipping this page
forever & so forth.
Once you click on
<OK>
button to go to the requested page, you can see the status page of
the ESR9850.
System:
You can see the UP time, hardware information, serial number as well as firmware
version information.
WAN Settings:
This section displays whether the WAN port is connected to a Cable/DSL
connection. It also displays the router’s WAN IP address, Subnet Mask, and ISP
Gateway as well as MAC address, the Primary DNS. Press
<Renew>
button to renew
your WAN IP address.
LAN Settings:
This section displays the Broadband router LAN port’s current LAN & WLAN
information. It also shows whether the DHCP Server function is enabled / disabled.
19216811.live