126
Router Login
Enter this URL in a web browser to run iQ Setup or
configure advanced settings. You must be
connected to the device by Wi
‐
Fi or Ethernet
cable.
Username/Password
This is the default username and password to
access the browser based configuration interface
when you go to the “Router Login” URL (above).
Wi
‐
Fi Network
Name
This is the default Wi
‐
Fi network name for the
device. Search for this name (SSID) and connect to
it in order to access the “Router Login” URL
(above).
MAC
A MAC address is unique to every device and is
used for identification within a network. Your
device’s unique MAC address is displayed here.
PIN CODE
This is your device’s PIN code for Wi
‐
Fi Protected
Setup (WPS).
5.
I forgot my password.
a.
Reset the router to its factory default settings and use the default username
admin
and default password
1234
. Default settings are displayed on the product
label on the back of the device, as shown above.
6.
My BR
‐
6228nS V2/nC V2 has a weak wireless signal in range
extender mode.
a.
Weak signals are usually caused by interference from other devices or obstacles
blocking the BR
‐
6228nS V2/nC V2’s wireless signal:
b.
Keep the device away from other radio devices such as microwaves or wireless
telephones.
c.
Do not put the device in the corner of a room or under/nearby metal.
d.
Ensure there are as few obstacles as possible between the BR
‐
6228nS V2/nC V2
and your wireless network device.
In range extender mode
, the BR
‐
6228nS V2/nC V2’S weak wireless signal may be in
turn caused by a weak signal from your existing router. It’s important to choose a
good location for the BR
‐
6228nS V2/nC V2
in relation to your existing wireless
router
. The best location is roughly in the middle between your existing wireless
router and the area you would like to be covered by the BR
‐
6228nS V2/nC V2. If
you are too far away from your existing router, then it is difficult for the BR
‐
6228nS
V2/nC V2 to receive a wireless signal.
19216811.live