1. Home
    2. /
  2. Manuals
    3. /
  3. EDIMAX
    4. /
  4. BR-6215SRG
    5. /
  5. 3
Page 11 / 16 Scroll up to view Page 6 - 10
9
5.
Select
“PPPoE xDSL”
, the system will move into next step
6.
Enter the
“User Name”
and
“Password”
that ISP provided
and leave the others. (The
“Service Name”
can be blank) and
click
“OK”
to save the setting then reboot the router
7.
After reboot, your router is now ready for Internet connection.
Note: Check the manual on the CD for more Internet
connection type and other setting details
Page 12 / 16
10
Router Configuration - Cable Modem
1.
The following example is for U.K. Click on
“Quick Setup”
.
2.
Select ‘(GMT) Greenwich Mean Time : “London”. Click
“Next”
button.
Page 13 / 16
11
3.
Select
“Cable Modem”
, the system will move into next step
4.
Enter
”Host Name”
and
“MAC Address”
. (The
“Host Name”
can be blank) The MAC Address is provided by ISP (e.g. NTL)
or click
“Clone Mac Address”
button if you’re using the
computer’s MAC Address.
Confirm with your ISP about MAC Address used, Click
“OK”
button to save the settings then reboot the router.
5.
After reboot, your router is now ready for Internet connection.
Note: Check the manual on the CD for more Internet
connection type and other setting details
Page 14 / 16
12
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of FCC Rules.
These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio technician for help.
FCC Caution
This device and its antenna must not be co-located or operating in
conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the authority to operate equipment.
Federal Communications Commission (FCC) Radiation
Exposure Statement
This equipment complies with FCC radiation exposure set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding the
FCC radio frequency exposure limits, human proximity to the antenna shall
not be less than 2.5cm (1 inch) during normal operation.
Page 15 / 16
13
Federal Communications Commission (FCC) RF Exposure Requirements
SAR compliance has been established in the laptop computer(s)
configurations with PCMCIA slot on the side near the center, as tested in
the application for Certification, and can be used in laptop computer(s) with
substantially similar physical dimensions, construction, and electrical and
RF characteristics. Use in other devices such a PDAs or lappads is not
authorized.
This transmitter is restricted for use with the specific antenna(s) tested in
the application for Certification. The antenna(s) used for this transmitter
must not be co-located or operating in conjunction with any other antenna
or transmitter.
R&TTE Compliance Statement
This equipment complies with all the requirements of DIRECTIVE
1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of
March 9, 1999 on radio equipment and telecommunication terminal
Equipment and the mutual recognition of their conformity (R&TTE)
The R&TTE Directive repeals and replaces in the directive 98/13/EEC
(Telecommunications Terminal Equipment and Satellite Earth Station
Equipment) As of April 8, 2000.
Safety
This equipment is designed with the utmost care for the safety of those who
install and use it. However, special attention must be paid to the dangers of
electric shock and static electricity when working with electrical equipment.
All guidelines of this and of the computer manufacture must therefore be
allowed at all times to ensure the safe use of the equipment.
EU Countries Intended for Use
The ETSI version of this device is intended for home and office use in
Austria, Belgium, Denmark, Finland, France, Germany, Greece, Ireland,
Italy, Luxembourg, the Netherlands, Portugal, Spain, Sweden, and the
United Kingdom.
The ETSI version of this device is also authorized for use in EFTA member
states: Iceland, Liechtenstein, Norway, and Switzerland.
EU Countries not intended for use
None

Rate

3.5 / 5 based on 2 votes.

Popular EDIMAX Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top