Page 236 / 241
Scroll up to view Page 231 - 235
Vigor2130 Series User’s Guide
228
For Static Users
1.
Choose
Static IP
as the connection type.
2.
Check if
IP Address, IP Mask
and
IP Router
are set correctly (must identify with the
values from your ISP).
For PPPoE Users
1.
Choose
PPPoE
as the connection type.
2.
Check if
Username
and
Password
are set correctly (must identify with the values from
your ISP).
Page 237 / 241
Vigor2130 Series User’s Guide
229
For PPTP/L2TP Users
1.
Choose
PPTP/L2TP
as the connection type.
2.
Check if
Username
,
Password, IP address, Subnet Mask
are entered with correct
values that you
get from
your
ISP
.
5.5 Forcing Vigor Router into TFTP Mode for Performing the
Firmware Upgrade
1.
Press and hold the
Factory Reset
button. The system will power off and power on the
Vigor Router.
2.
Release the
Factory Reset
button when the ACT LED and its neighbor LED blink
simultaneously.
There are different LED blinking methods in describing TFTP mode status:
Vigor2130: ACT LED & its neighbor LED blink simultaneously.
3.
4.
Open
Firmware Upgrade Utility
5.
Install
Router Tools
on one computer that connects to Vigor Router's LAN port.
6.
Make sure the computer can ping Vigor's LAN IP. ( Default IP is
192.168.1.1 )
7.
Run
Router Tools >> Firmware Upgrade Utility
.
8.
Input Vigor's LAN IP manually or use the
. .
.button to select.
9.
Indicate the firmware location.
Note:
There are two firmware types. The
.rst
firmware format will make the
configurations be back to default settings after upgrading firmware. The
.all
firmware format will remain the former configurations after upgrading firmware.
Page 238 / 241
Vigor2130 Series User’s Guide
230
10.
Input the Password if you have set one, then click
Send
.
11.
There is a bar showing the upgrading process.
12.
When the firmware upgrade is successful, the following window will pop up.
Page 239 / 241
Vigor2130 Series User’s Guide
231
If the message of
Request Timeout. Transfer Abort !
appears, please check if the connection
between the computer and the Vigor is active or not. And, if the message of
Incorrect/No file
name.
Transfer Abort !
appears, please check if the firmware you download is correct for
your Vigor router.
Note:
Please turn off the Firewall protection while upgrading the firmware with Windows
Vista. The Firewall function can be turned off via
Control Panel >> Security Center >>
Firewall
.
Page 240 / 241
Vigor2130 Series User’s Guide
232
5.6 Backing to Factory Default Setting If Necessary
Sometimes, a wrong connection can be improved by returning to the default settings. Try to
reset the router by software or hardware.
Warning:
After pressing
factory default setting
, you will loose all settings you did before.
Make sure you have recorded all useful settings before you pressing.
Software Reset
You can reset the router to factory default via Web page.
Go to
System Maintenance
and
choose
Reboot System
on the web page. The following
screen will appear. Choose
Using factory default configuration
and click
OK
. After few
seconds, the router will return all the settings to the factory settings.
Hardware Reset
While the router is running (ACT LED blinking), press the
Factory Reset
button and hold for
more than 5 seconds. When you see the
ACT
LED blinks rapidly, please release the button.
Then, the router will restart with the default configuration.
After restore the factory default setting, you can configure the settings for the router again to
fit your personal request.
19216811.live