Page 6 / 42
Scroll up to view Page 1 - 5
Quick Installation Guide
³
Quick Installation Guide
With the Dovado UMR you can access the Internet wirelessly. In
addition to the UMR you need a computer. The product can be set up
using a common web browser.
Hardware installation
Before continuing, you will need to
install the necessary hardware;
±.
Connect the WLAN antenna
to the UMR unit.
2.
If you do not intend on wall
mounting your UMR, then
add the included rubber feet
to the designated points on the
base of your UMR.
².
Insert the USB Modem into the
UMR.
³.
Connect the power supply to a wall socket and to the PWR
connector located at the back of the UMR.
5.
Please note that the USB modem should not be replaced during
operation, if you need to replace the modem, power off the UMR
first.
6.
Peel off the protective layer from the front panel.
A solid green light on the power LED (
) indicates that the unit is
working.
Page 7 / 42
Quick Installation Guide
5
The reset button
The location of the reset button is at the back of the UMR. If you
need to erase all the inserted parameters and password, along with
restoring the factory defaults settings, then hold down the reset button
for approximately 8 seconds.
1.
Wireless LAN (WLAN) antenna
2.
DC Power Input
3.
Reset button
4.
USB ports 1-2
5.
LAN ports 1-4
6.
WAN port (reserved for future use)
1
6
4
3
2
5
Page 8 / 42
Quick Installation Guide
6
Connecting by Ethernet cable
Make sure your computer and UMR are turned on. Connect one end
of the Ethernet cable to the Ethernet port on your computer and the
other end to one of the LAN ports on the UMR. A connection will
now automatically be established and when ready, it will be indicated
by a solid green light on the LAN LED.
Connecting by Wireless LAN
(WLAN/WiFi)
Ensure that your computer and UMR are turned on and that the Wireless
LAN (WLAN/WiFi) is activated on your computer. Establish a Wireless
LAN connection to the UMR (this process should be described in detail
within the product manual for your computer or for the Wireless LAN
network card). The Wireless LAN name (SSID) is
DOVADO
.
If these steps did not yield any results, then please verify that the network
(LAN or WLAN) interface on your computer is using a dynamic
(DHCP) IP address.
Page 9 / 42
Quick Installation Guide
´
Accessing the UMR
Once you have connected a computer with either an Ethernet cable
or by Wireless LAN, open your web browser and access the following
website:
Address:
Username:
admin
Password:
password
After clicking on
Login
, you will be taken to the
Home
page which will
display all the information about your UMR.
Page 10 / 42
Quick Installation Guide
µ
Wizard Configuration
Go to
Home
and then click on
Start Wizard
link to start the setup
wizard. It will be opened in a new window. Follow the steps below to
finish the installation.
Welcome
The welcome screen presents the steps that you will be guided through.
Click on
Next
to continue.
19216811.live