Page 56 / 66 Scroll up to view Page 51 - 55
56
D-Link EBR-2310 User Manual
Appendix D - Sharing an LPR Printer
• From the pull-down menu, select
Standard TCP/IP Port
, as shown.
• Click
Next
• Please read the instructions on this screen.
• Click
Next
• Enter the
Printer IP Address
and the
Port Name
, as shown.
• Click
Next
Page 57 / 66
57
D-Link EBR-2310 User Manual
Appendix D - Sharing an LPR Printer
• In this screen, select
Custom.
• Click
Settings
• Enter the
Port Name
and the
Printer Name
or
IP Address
.
• Select
LPR
• Enter a
Queue Name
(if your Print-Server/Gateway has
more than one port, you will need a
Queue name
.)
• Click
OK
Page 58 / 66
58
D-Link EBR-2310 User Manual
Appendix D - Sharing an LPR Printer
• This screen will show you information about your printer.
• Click
Finish
• Select the
printer
you are adding from the list of
Printers
.
• Insert the printer driver disk that came with your printer.
• Click
Have Disk
If the printer driver is already installed,
• Select
Keep existing driver
• Click
Next
Page 59 / 66
59
D-Link EBR-2310 User Manual
Appendix D - Sharing an LPR Printer
• You can rename your printer if you choose. It is optional.
Please remember the name of your printer. You will need this information when
you use the
Add Printer Wizard
on the other computers on your network.
• Click
Next
• Select
Yes
, to print a test page.
• Click
Next
This screen will display information about your printer.
• Click
Finish
to complete the addition of the printer.
• Please run the
Add Printer Wizard
on all the computers on your
network in order to share the printer.
Note: You must run the
Network Setup Wizard
on all the computers on your
network before you run the
Add Printer Wizard
.
Page 60 / 66
60
D-Link EBR-2310 User Manual
Appendix E - Networking Basics
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a
DHCP server (i.e. wireless router) automatically. To verify your IP address, please follow the steps below.
Click on
Start
>
Run
. In the run box type
cmd
and click
OK
.
At the prompt, type
ipconfig
and press
Enter
.
This will display the IP address, subnet mask, and
the default gateway of your adapter.
If the address is 0.0.0.0, check your adapter
installation, security settings, and the settings
on your router. Some firewall software programs
may block a DHCP request on newly installed
adapters.
If you are connecting to a wireless network at a hotspot (e.g. hotel, coffee shop, airport), please contact an employee
or administrator to verify their wireless network settings.

Rate

3.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top