Page 21 / 34
Scroll up to view Page 16 - 20
21
Using the Configuration Utility (continued)
Tools > System
Apply settings and Restart.
Restart-
Restore to factory default settings.
Restore-
Page 22 / 34
22
Using the Configuration Utility (continued)
Tools > Firmware
After you have downloaded the most recent version of the firmware from
www.support.dlink.com you can
browse
your hard drive to locate the downloaded file.
Click
OK
to update the firmware.
Update File-
Page 23 / 34
23
Using the Configuration Utility (continued)
Tools > Cfg File
Browse
for the con-
figuration settings
that you have saved
to your hard drive.
Click
OK
when you
made your selection.
Update File-
Click
OK
to load the
selected settings.
Load Settings to
the Local Hard
Drive-
Tools > Misc.
Status-
Telnet Settings
Select a time period
after which a ses-
sion timeout will
occur.
Timeout-
Click to Enable a
Telnet session.
Page 24 / 34
24
Using the Configuration Utility (continued)
This window dis-
plays the settings
of
the
DWL-
2700AP, as well
as the Firmware
version and the
MAC address.
Status > Device Info
Status > Stats
This window dis-
plays the statis-
tics of the wireless
local area network.
Page 25 / 34
25
Using the Configuration Utility (continued)
Status > Indication
Indicates the
current tempera-
ture.
Temperature
Indication-
Indicates the
RSSI voltage.
Available only in
PtP Bridge, AP
Repeater, and
AP Client
modes.
RSSI
(Receiving
Signal Strength
Indication) -
Status > Client Info
Note:
The following two screens contain information about the device that is
communicating with the DWL-2700AP. This information is available only
when the DWL-2700AP is in point-to-point, client or repeater mode.
The MAC address
of the device com-
municating with
the DWL-2700AP.
MAC
-
The device is set
to the 802.11g
band.
Band
-
The device is set
to Open System.
Authentication
-
The device is set
to Open System.
RSSI
-
Power Saving
Mode
-
In this case, the communicating device is set to Power Save Off.
19216811.live