Page 41 / 58
Scroll up to view Page 36 - 40
41
Using the AP Manager (continued)
You can customize the basic System Settings
for the DWL-2200AP by clicking on this button.
System Settings
•
Access Password
: This sets the admin
password for the selected device(s).
•
Auto Refresh
: This setting allows you
to enable auto refreshing of the network
device list. By default this option is
disabled. If you choose to enable it, you
must enter the refresh interval in
seconds.
All other settings on this screen should be
left at the default setting.
This button will launch the Setup Wizard that will
guide you through device configuration.
Setup Wizard
Click
Next
Downloaded from
www.Manualslib.com
manuals search engine
Page 42 / 58
42
Using the AP Manager (continued)
Enter a
Password
and retype it
in
the
Verify Password
field.
Click
Next
Click
Next
Enter the
SSID
and the
Channel
for the network.
Downloaded from
www.Manualslib.com
manuals search engine
Page 43 / 58
43
Using the AP Manager (continued)
The DWL-2200AP setup is complete!
If you want to enable Encryption,
enter the Encryption values here.
Click
Next
Click
Finish
Downloaded from
www.Manualslib.com
manuals search engine
Page 44 / 58
44
Using the AP Manager (continued)
Refresh
About
Click on this button to
refresh the list
of devices
available on the network.
Click on this button to view the version
of AP Manager.
Devices with a checkmark
next to them are still
available on the network.
Devices with an X are no
longer available on the
network.
Downloaded from
www.Manualslib.com
manuals search engine
Page 45 / 58
45
1.The computer used to configure the DWL-2200AP cannot access
the configuration menu.
Check that the
Ethernet LED
on the DWL-2200AP is
ON
. If the
LED
is not
ON
, check that the cable for the Ethernet connection is
securely inserted.
Check that the Ethernet adapter is working properly. Please see
item 3
(
Check that the drivers for the network adapters are
installed properly
) in this
Troubleshooting
section to check that
the drivers are loaded properly.
Check that the
IP address
is in the same range and subnet as the
DWL-2200AP. Please see
Checking the IP Address
in Windows
XP
in the
Networking Basics
section of this manual.
Note: The IP address of the DWL-2200AP is
192.168.0.50. All the computers on
the network must have a unique IP address in the same range, e.g., 192.168.0.x.
Any computers that have identical IP addresses will not be visible on the
network. They must all have the same subnet mask, e.g., 255.255.255.0
Do a
Ping test
to make sure that the DWL-2200AP is responding.
Go to
Start
>
Run
>Type
Command
>Type
A
successful ping will show four replies.
Troubleshooting
This chapter provides solutions to problems that can occur during the installation and
operation of the DWL-2200AP. We cover various aspects of the network setup, including
the network adapters. Please read the following if you are having problems.
Note: If you have
changed the default IP
address, make sure to
ping the correct IP
address assigned to the
DWL-2200AP.
±
±
±
±
Note:
It is recommended that you use an Ethernet connection to
configure the DWL-2200AP Wireless Access Point.
Downloaded from
www.Manualslib.com
manuals search engine
19216811.live