Page 11 / 100
Scroll up to view Page 6 - 10
11
Click
Restart
Your setup is complete.
You may now connect your wireless clients to the access point. If you have
enabled either WEP or WPA-Personal security, you must enable it and
enter the WEP key or WPA passphrase exactly the same on your wireless
clients.
Page 12 / 100
12
To connect to the access point using a Windows
®
XP computer, follow the
steps below. Your wireless adapter may have a site survey feature which
is similar to the Windows
®
XP utility as shown below.
If you receive the
Wireless Networks
Detected
bubble, click on the center
of the bubble to access the utility.
Connect to the Wireless Network
You may also right-click on the
wireless computer icon in your
system tray (lower-right corner next
to the time). Select
View Available
Wireless Networks
.
The utility will display any available wireless networks in your area. Click
on a network (the SSID you entered when configuring your access point)
and click the
Connect
button.
Page 13 / 100
13
Assigning a Static IP Address
To assign a Static IP Address on the computer that you are using to configure
the DWL-2200AP, follow the steps for the appropriate operating system:
Windows
®
XP:
Go to
Start
, click on
Control
Panel,
double-click on
Network
Connections
,
right-click on
Local
Area Connections
and select
Properties
.
Highlight
Internet Protocol
(TCP/IP)
Click
Properties
IP address: 192.168.0.51
Subnet mask: 255.255.255.0
Input a static IP address in the
same range as the DWL-2200AP’s
computer/device must have a
unique IP address.
Click
OK
Select
Use the following IP
address
Page 14 / 100
14
Go to
Start
>
Settings
>
Network
and Dial-up Connections
.
Double-click on the Local Area
Connection associated with the
Network Adapter installed on your
system and select
Properties
.
Windows
®
2000:
IP address: 192.168.0.52
Subnet mask: 255.255.255.0
Input a static IP address in the
same range as the DWL-2200AP’s
computer/device must have a
unique IP address.
Click
Properties
Click
Internet Protocol (TCP/IP)
Select
Use the following IP
address
Click
OK
Page 15 / 100
15
Using Power over Ethernet
Step 1:
Connect one end of an Ethernet cable (included with your package)
to the LAN port on the DWL-2200AP and the other end of the Ethernet cable
to the port labeled P+DATA OUT on the PoE base unit.
Step 2:
Connect another Ethernet cable from the DATA IN port on the PoE
base unit to your router/switch or to a PC.
Step 3:
Attach the power adapter to the connector labeled POWER IN on
the PoE base unit. Attach the power cord to the power adapter and into an
electrical outlet.
19216811.live