Page 176 / 270
Scroll up to view Page 171 - 175
Unified Services Router
User Manual
174
Figure 122: Dynamic DNS configuration
9.9
Using Diagnostic Tools
Tools > System Check
The router has built in tools to allow an administrator to evaluate the communication
status and overall network health.
Page 177 / 270
Unified Services Router
User Manual
175
Figure 123: Route r diagnostics tools available in the GUI
9.9.1 Ping
This utility can be used to test connectivity between this router and another device
on the network connected to this router. Enter an IP address and click PING. The
command output will appear indicating the ICMP echo request status.
9.9.2 Trace Route
This utility will display all the routers present between the destination IP address
and this router. Up to 30 “hops” (intermediate routers) between this router and the
destination will be displayed.
Page 178 / 270
Unified Services Router
User Manual
176
Figure 124: Sample trace route output
9.9.3 DNS Lookup
To retrieve the IP address of a Web, FTP, Mail or any other s erver on the Internet,
type the Internet Name in the text box and click Lookup. If the host or domain entry
exists, you will see a resp
onse with the IP address. A message stating “Unknown
Host” indicates that the specified Internet Name does not exist.
This feature assumes there is internet access available on the WAN link(s).
9.9.4 Router Options
The static and dynamic routes configured on this router can be shown by clicking
Display for the corresponding routing table. Clicking the Packet Trace button will
allow the router to capture and display traffic through the DSR between the LAN
and WAN interface as well. This information is often very u seful in debugging
traffic and routing issues.
Page 179 / 270
Unified Services Router
User Manual
177
9.10 Localization
Tools > Set Language
The router has built in tools to allow change the default language (English) to four
different languages . (French, Deutsche, Spanish and Italian )
Figure 125: Localizatio n
Page 180 / 270
Unified Services Router
User Manual
178
Chapter
10.
Router Status and
Statistics
10.1 System Overview
The Status page allows you to get a detailed overview of the system configuration.
The settings for the wired and wireless interfaces are displayed in the DSR Status
page, and then the resulting hardware resource and router usage details are
summarized on the router’s Dashboard.
10.1.1 Device Status
Status > Device Info > Device Status
The DSR Status page gives a summary of the router configuration settings
configured in the Setup and Advanced menus. The static hardware serial number and
current firmware version are presented in the General section. The WAN and LAN
interface information shown on this page are based on the administrator
configuration parameters. The radio band and channel settings are presented below
along with all configured and active APs that are enabled on this router.
19216811.live