12

D-Link DSL-4320L User Manual

Section 2 - Installation

6

7

If connecting to the DSL-4320L wirelessly, access the wireless utility on your computer or mobile device. Scan

for available Wi-Fi networks (SSID). Select and join a Wi-Fi network and use the password which corresponds

to the information on the supplied Wi-Fi Configuration Card.

Press the power button and verify that the power LED is lit. Allow 1 minute for the router to boot up.

Wi-Fi Configuration Note

13

D-Link DSL-4320L User Manual

Section 3 - Getting Started

There are two ways you can configure your router to connect to the Internet and connect to your clients:

•

D-Link Setup Wizard

- This wizard will launch when you log into the router for the first time. Refer to page "Setup Wizard"

on page 14.

•

Manual Setup

- Log into the router and manually configure your router. Refer to "Configuration" on page 61.

Getting Started

14

D-Link DSL-4320L User Manual

Section 3 - Getting Started

Setup Wizard

If this is your first time installing the router, open your web browser and

enter

http://dlinkrouter.local./

in the address bar.

Alternatively, enter

the IP address of the router (default:

).

The wizard is designed to guide you through a step-by-step process to

configure your new D-Link router and connect to the Internet.

Click

Next

to continue.

Ensure that your DSL phone cable is connected to both the router and

the wall jack.

Click

Next

to continue.

15

D-Link DSL-4320L User Manual

Section 3 - Getting Started

If the router does not detect a valid Internet connection, a list of

connection types to choose from will be displayed.

Select your Internet connection type (this information can be obtained

from your Internet Service Provider) and click

Next

to continue.

If the router detected or you selected

PPPoE

, enter your PPPoE username

and password and click

Next

to continue.

Note:

Make sure to remove your PPPoE software from your computer. The

software is no longer needed and will not work through a router.

16

D-Link DSL-4320L User Manual

Section 3 - Getting Started

If the router detected or you selected

PPPoA

, enter your PPPoA username

and password and click

Next

to continue.

Note:

Make sure to remove your PPPoA software from your computer. The

software is no longer needed and will not work through a router.

If the router detected or you selected

Static

, enter the IP and DNS settings

supplied by your ISP. Click

Next

to continue.