This window displays the Router’s xDSL statistics.
Click the
Reset Statistics
button to refresh these statistics.
Click the
xDSL BER Test
button to access the ADSL Bit Error Rate Test
window displayed below:
Page 22 / 128
D-Link DSL-2760U USER’S MANUAL
22
Route
To access the
Device Info
–
Route
window, click the
Route
button in the
Device Info
directory.
Route:
This read-only window displays routing info.
ARP
To access the
Device Info
–
ARP
window, click the
ARP
button in the
Device Info
directory.
ARP:
This read-only window displays Address Resolution Protocol
info.
Page 23 / 128
D-Link DSL-2760U USER’S MANUAL
23
DHCP
To access the
Device Info – DHCP
window, click the
DHCP
option in the
Device Info
directory. This option will only be available if DHCP is enabled in the LAN
settings.
DHCP:
This read-only window displays a list of current DHCP clients
that are connected to this router.
Page 24 / 128
D-Link DSL-2760U USER’S MANUAL
24
Advanced Setup
This chapter includes the more advanced features used for network management and security as well as administrative tools to manage the Router view status
and other information used to examine performance and for troubleshooting.
Page 25 / 128
D-Link DSL-2760U USER’S MANUAL
25
Layer2 Interface
ATM Interface:
Choose
Add
, or
Remove
to configure DSL ATM interfaces.
This screen allows you to configure an
ATM PVC identifier
(VPI and VCI),
select DSL latency, and select a service category. Otherwise choose an existing
interface by selecting the checkbox to enable it.
Select
Select DSL Link Type (EoA is for PPPoE, IPoE, and Bridge.)
,
Encapsulation Mode
and
Service Category
.
Enabling packet level QoS for PVC improves performance for selected classes
of applications. QoS cannot be set for CBR and Real-time VBR. QoS
consumes system resources; therefore the number of PVCs will be reduced.
Use Advanced Setup/Quality of Service to assign priorities for the applications.
19216811.live