Page 66 / 86 Scroll up to view Page 61 - 65
Appendix A – Troubleshooting
D-Link DSL-2640U User Manual
66
Certificates
To access the
Local Certificates
window, click the
Certificates
button in the
Advanced Setup
directory.
Local
This window is used to add, view or remove
Local certificates
.
Local certificates are used by peers to verify your identity.
Maximum 4 certificates can be stored.
Trusted CA
This window is used to add, view or remove
CA certificates
.
CA certificates are used by you to verify peers' certificates.
Maximum 4 certificates can be stored.
Page 67 / 86
Appendix A – Troubleshooting
D-Link DSL-2640U User Manual
67
Wireless
Press
Wireless
in the left menu to enter wireless section. You can select to configure wireless setup, security and management.
Basic
This page is to configure basic settings of wireless LAN.
Click
Enable
Wireless
, enter a wireless network name (SSID) and select
a country to active the wireless LAN. You can also hide the network (Hide
Access Point), isolate users (Clients Isolation).
Click
Save/Apply
to save the settings.
Page 68 / 86
Appendix A – Troubleshooting
D-Link DSL-2640U User Manual
68
Security
This window is used to configure
Wireless
Security
.
You can select to configure WEP encryption, Shared, 802.1x,
WPA, and WPA2 authentication.
Page 69 / 86
Appendix A – Troubleshooting
D-Link DSL-2640U User Manual
69
WEP Encryption
Select
Enabled
of the WEP encryption list. You can enter
WEP encryption page.
Encryption Strength
: Key length: 128bits or 64bits.
Network Key 1-4
: Up to four keys that are in form of hex
digitals could be set. Mobile users can’t access the AP if they
haven’t set the same key as AP. For 64bits and 128bits keys,
you should input 10 and 26 hexadecimal digitals or 5 and 13
ASCII characters respectively. Every two digitals should be
compared with others by a space character. For example:
“7890ABCDEF” (hexadecimal digitals) or “QWERT” (ASCII
characters) for a key length of 64bits.
Page 70 / 86
Appendix A – Troubleshooting
D-Link DSL-2640U User Manual
70
802.1x Authentication
Select
802.1x
to enter 802.1x authentication page.
The 802.1x authentication needs a Radius server in LAN. In
this page, you can input Radius server IP address, port
number and secret key.

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top