Configure the wireless network. Enter the information and click
Next
.
Page 27 / 91
Web Configuration
D-Link DSL-2640B User Manual
23
The page shown in the right figure appears. In this page, you can view the configuration
information.
When the settings are complete, click
Restart
to apply the settings and reboot the device.
Note:
In each step of the Wizard page, you can click
Back
to review or modify the
previous settings. Click
Cancel
to exit the wizard page.
Page 28 / 91
Web Configuration
D-Link DSL-2640B User Manual
24
Internet Setup
Choose
SETUP
>
Internet Setup
. The page as shown in the figure appears:
Page 29 / 91
Web Configuration
D-Link DSL-2640B User Manual
25
In this page, you can configure the WAN interface of the device.
Click
Add
and the page as shown in the figure appears:
The table describes the parameters in this page.
Field
Description
ATM PVC CONFIGURATION
VPI
Virtual Path Identifier (VPI) is the virtual path between two
points in an ATM network. Its value range is from 0 to 255.
VCI
Virtual Channel Identifier (VCI) is the virtual channel
between two points in an ATM network. Its value range is
from 32 to 65535 (0 to 31 is reserved for local
MAINTENANCE of ATM traffic).
Service Category
Select
UBR with PCR
,
UBR without PCR
,
CBR
,
Non
Realtime VBR
, or
Realtime VBR
from the drop-down list.
Peak Cell Rate
Set the maximum transmission rate of the cell in ATM
transmission.
Sustainable
Cell
Rate
Set the minimum transmission rate of the cell in ATM
transmission.
Maximum
Burst
Size
Set the maximum burst size of the cell in ATM
transmission.
CONNECTION TYPE
Protocol
Select
PPP over ATM (PPPoA)
,
PPP over Ethernet
(PPPoE)
,
MAC Encryption Routing (MER)
,
IP over ATM
,
or
Bridging
from the drop-down list.
Encapsulation
Mode
Select
LLC
or
VCMUX
from the drop-down list. Usually,
you can select
LLC
.
BRIDGE SETTINGS
Enable
Bridge
Service
Select or deselect the check box to enable or disable the
WAN connection.
Service Name
The name to identify the WAN connection. You need not
modify it.
Page 30 / 91
Web Configuration
D-Link DSL-2640B User Manual
26
Wireless Settings
This section describes the wireless LAN and some basic configuration. Wireless LANs can be as simple as two computers with wireless LAN cards communicating in a
pear-to-pear network or as complex as a number of computers with wireless LAN cards communicating through access points which bridge network traffic to wired LAN.
Choose
Setup
>
Wireless Settings
. The
Wireless Settings
page shown in the right
figure appears.
Wireless Basics
In the
Wireless Settings
page, click
Wireless Basics
.
The page shown in the right
figure appears.
In this page, you can configure the parameters of wireless LAN clients
that may connect to the device.
The wireless channel is from 1 to 11.
You can select the 802.11 mode from the drop-down list.
19216811.live