1. Home
    2. /
  2. Manuals
    3. /
  3. D-Link
    4. /
  4. DIR-862L
    5. /
  5. 30
Page 146 / 151 Scroll up to view Page 141 - 145
142
D-Link DIR-862L User Manual
Appendix A - Wireless Basics
Security
Don’t let you next-door neighbors or intruders connect to your wireless network. Secure your wireless network by turning on
the WPA or WEP security feature on the router.
There are basically two modes of networking:
•
Infrastructure
– All wireless clients will connect to an access point or wireless router.
•
Ad-Hoc
– Directly connecting to another computer, for peer-to-peer communication, using wireless network
adapters on each computer.
An Infrastructure network contains an Access Point or wireless router. All the wireless devices, or clients, will connect to the
wireless router or access point.
An Ad-Hoc network contains only clients, such as Wi-Fi enabled laptops. All the adapters must be in Ad-Hoc mode to
communicate.
Wireless Modes
Page 147 / 151
143
D-Link DIR-862L User Manual
Appendix B - Networking Basics
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP
server (i.e. wireless router) automatically. To verify your IP address, please follow the steps below.
Click on
Start
>
Run
. In the run box type
cmd
and click
OK.
(Windows® 7/Vista® users type
cmd
in the
Start Search
box.)
At the prompt, type
ipconfig
and press
Enter
.
This will display the IP address, subnet mask, and the
default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation,
security settings, and the settings on your router.
Some firewall software programs may block a DHCP
request on newly installed adapters.
Page 148 / 151
144
D-Link DIR-862L User Manual
Appendix B - Networking Basics
Statically Assign an IP address
If you are not using a DHCP capable gateway/router, or you need to assign a static IP address, please follow the steps below:
Step 1
Windows® 7 -
Click on
Start
>
Control Panel
>
Network and Internet
>
Network and Sharing Center
.
Windows Vista® -
Click on
Start
>
Control Panel
>
Network and Internet
>
Network and Sharing Center
>
Manage Network
Connections.
Windows® XP -
Click on
Start
>
Control Panel
>
Network Connections
.
Windows® 2000 -
From the desktop, right-click
My Network Places
>
Properties
.
Step 2
Right-click on the
Local Area Connection
which represents your network adapter and select
Properties
.
Step 3
Highlight
Internet Protocol (TCP/IP)
and click
Properties
.
Step 4
Click
Use the following IP address
and enter an IP address that is on the same subnet
as your network or the LAN IP address on your router.
Example: If the router´s LAN IP address is 192.168.0.1, make your IP address 192.168.0.X
where X is a number between 2 and 99. Make sure that the number you choose is not
in use on the network. Set the Default Gateway the same as the LAN IP address of your
router (e.g. 192.168.0.1).
Set Primary DNS the same as the LAN IP address of your router (192.168.0.1). The
Secondary DNS is not needed or you may enter a DNS server from your ISP.
Step 5
Click
OK
twice to save your settings.
Page 149 / 151
145
D-Link DIR-862L User Manual
Appendix C - Technical Specifications
Technical Specifications
Hardware Specifications
•
LAN Interface: Four 10/100/1000 Gigabit LAN ports
•
WAN Interface: 10/100/1000 Gigabit WAN port
•
Wireless Interface (2.4 GHz): IEEE 802.11b/g/n
•
Wireless Interface (5 GHz): IEEE 802.11a/n/ac
•
USB Interface: USB 2.0 Compliant
Operating Voltage
•
Input: 100~240V (±20%), 50~60Hz
•
Output: DC12V, 2A
Temperature
•
Operating: 32 ~ 104
o
F (0 ~ 40
o
C)
•
Non-Operating: -4 ~ 149
o
F (-20 ~ 65
o
C)
Humidity
•
Operating: 10% - 90% non-condensing
•
Non-Operating: 5% - 95% non-condesing
Standards
•
IEEE 802.11ac (draft)
•
IEEE 802.11n
•
IEEE 802.11g
•
IEEE 802.11b
•
IEEE 802.11a
•
IEEE 802.3
•
IEEE 802.3u
Wireless Bandwidth Rate
•
IEEE 802.11a:
54, 48, 36, 24, 18, 12, 9, and 6 Mbps
•
IEEE 802.11b: 11, 5.5, 2, and 1 Mbps
•
IEEE 802.11g: 54, 48, 36, 24, 18, 12, 9, and 6 Mbps
•
IEEE 802.11n: 6.5 to 450 Mbps
•
IEEE 802.11ac: 6.5 to 1299.9 Mbps
Antenna Type
•
Six Internal Antennas (Three 2.4 GHz Antennas, Three 5 GHz
Antennas)
Wireless Security
•
64/128bit WEP, WPA/WPA2-Personal, WPA/WPA2-Enterprise, WPS
(PIN & PBC)
•
FCC, IC
•
Wi-Fi / WPS
•
IPv6 Ready
•
WIN 8
Certifications
•
FCC, IC
•
cUL
•
Wi-Fi / WPS
•
IPv6 Ready
•
WIN 8
Page 150 / 151
146
D-Link DIR-862L User Manual
Appendix D - Compliance Statements
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement est sujet
aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu,
y compris un brouillage susceptible de provoquer un fonctionnement indésirable.

Rate

3.5 / 5 based on 2 votes.

Popular D-Link Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top