Page 81 / 120
Scroll up to view Page 76 - 80
77
D-Link DIR-859 User Manual
Section 5 - Connecting to a Wireless Network
3. Double-click the DIR-859.
4. Input the WPS PIN number (on the router label) in the
Setup
>
Wireless
Setup
menu in the Router’s Web UI) and click
Next
.
Page 82 / 120
78
D-Link DIR-859 User Manual
Section 5 - Connecting to a Wireless Network
5. Type a name to identify the network.
6. To configure advanced settings, click the
icon.
Click
Next
to continue.
Page 83 / 120
79
D-Link DIR-859 User Manual
Section 5 - Connecting to a Wireless Network
7. The following window appears while the Router is being configured.
Wait for the configuration to complete.
8. The following window informs you that WPS on the router has been
set up successfully.
Make a note of the security key as you may need to provide this security
key if adding an older wireless device to the network in the future.
9. Click
Close
to complete WPS setup.
Page 84 / 120
80
D-Link DIR-859 User Manual
Section 5 - Connecting to a Wireless Network
Windows Vista®
Windows Vista® users may use the built-in wireless utility. If you are using another company’s wireless utility, please refer to the
user manual of your wireless adapter for help connecting to a wireless network. Most wireless utilities will have a “site survey”
option similar to the Windows Vista® utility as seen below.
Right-click on the wireless computer icon in your system tray (lower-right
corner next to the time). Select
Connect to a network
.
If you receive the
Wireless Networks Detected
bubble, click on the
center of the bubble to access the utility.
or
The utility will display any available wireless networks in your area. Click
on a network (displayed using the SSID) and click the
Connect
button.
If you get a good signal but cannot access the Internet, check you
TCP/IP settings for your wireless adapter. Refer to the
Networking Basics
section in this manual for more information.
Page 85 / 120
81
D-Link DIR-859 User Manual
Section 5 - Connecting to a Wireless Network
WPA/WPA2
It is recommended that you enable wireless security (WPA/WPA2) on your wireless router or access point before configuring
your wireless adapter. If you are joining an existing network, you will need to know the security key or passphrase being used.
2.
Highlight the Wi-Fi name (SSID) you would like to connect to and
click
Connect
.
1.
Open the Windows Vista® Wireless Utility by right-clicking on the
wireless computer icon in your system tray (lower right corner of
screen). Select
Connect to a network
.
19216811.live