D-Link DIR-825 Router Manual PDF (Setup & Configuration Guide)

Home

Manuals

D-Link

DIR-825

Page 156 / 158 Scroll up to view Page 151 - 155

151

D-Link DIR-825 User Manual

Appendix F - Warranty

FCC.Statement:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are

designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment oﬀ and on, the user is encouraged to try to correct the interference by

one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit diﬀerent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC.Caution:.

Any changes or modiﬁcations not

expressly approved by the party responsible for compliance could void the user’s authority to operate this

equipment.

Operations in the 5.15-5.25GHz / 5.470 ~ 5.725GHz band are restricted to indoor usage only.

IMPORTANT.NOTICE:

FCC.Radiation.Exposure.Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and

operated with minimum distance 20cm between the radiator & your body. To maintain compliance with FCC RF exposure compliance requirements,

please avoid direct contact to the transmitting antenna during transmitting.

If this device is going to be operated in 5.15 ~ 5.25GHz frequency range, then it is restricted in indoor environment only. This transmitter must not

be co-located or operating in conjunction with any other antenna or transmitter.

The availability of some speciﬁc channels and/or operational frequency bands are country dependent and are ﬁrmware programmed at the factory

to match the intended destination. The ﬁrmware setting is not accessible by the end user.

Page 157 / 158

152

D-Link DIR-825 User Manual

Appendix F - Warranty

ICC.Notice:

Operation is subject to the following two conditions:

1) This device may not cause interference and

2) This device must accept any interference, including interference that may cause undesired operation of the device.

IMPORTANT.NOTE:

IC.Radiation.Exposure.Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the speciﬁc operating

instructions for satisfying RF exposure compliance. This equipment should be installed and operated with minimum distance 20cm between the

radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

(i)

The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to

co-channel mobile satellite systems;

(ii)

The maximum antenna gain (2dBi) permitted (for devices in the band 5725-5825 MHz) to comply with the e.i.r.p. limits speciﬁed

for point-to-point and non point-to-point operation as appropriate, as stated in section A9.2(3).

In addition, users should also be cautioned to take note that high-power radars are allocated as primary users (meaning they have priority) of the

bands 5250-5350 MHz and 5650-5850 MHz and these radars could cause interference and/or damage to LE-LAN devices.

Règlement.d’Industry.Canada.

Les conditions de fonctionnement sont sujettes à deux conditions:

(1)

Ce périphérique ne doit pas causer d’interférence et.

(2) Ce périphérique doit accepter toute interférence, y compris les interférences pouvant perturber le bon fonctionnement de

ce périphérique.

Page 158 / 158

153

D-Link DIR-825 User Manual

Appendix G - Registration

Version 3.0

November 30, 2011

Product registration is entirely voluntary and failure to complete or return this form will not diminish your warranty rights.

Registration

Rate

Popular D-Link Models

Famous Router IPs

Famous Router Companies

Bookmark Our Site

Share