19216811.liveENGLISH
establish a L2TP connection.
Subnet Mask
Enter the Subnet Mask provided by your ISP
(e.g. 255.255.255.0)
Gateway
Enter the IP address of the ISP Gateway
User ID
Enter the User Name provided by your ISP for the L2TP
connection. Sometimes called a Connection ID
Password
Enter the Password provided by your ISP for the L2TP
connection
L2TP Gateway
If your LAN has a L2TP gateway, then enter that L2TP
gateway IP address here. If you do not have a L2TP
gateway then enter the ISP’s Gateway IP address above
Connection Type
If you select “Continuous”, the router will always connect to
the ISP. If the WAN line breaks down and links again, the
router will auto-reconnect to the ISP.
If you select “Connect On Demand”, the router will auto-
connect to the ISP when someone want to use the Internet
and keep connected until the WAN idle timeout. The router
will close the WAN connection if the time period that no one
is using the Internet exceeds the “Idle Time”.
If you select “Manual”, the router will connect to ISP only
when you click “Connect” manually from the Web user
interface. The WAN connection will not disconnected due to
the idle timeout. If the WAN line breaks down and latter links
again, the router will not auto-connect to the ISP.
Idle Time Out
You can specify an idle time threshold (minutes) for the WAN
port. This means if no packets have been sent (no one using
the Internet) throughout this specified period, then the router
will automatically disconnect the connection with your ISP.
Note:
This “idle timeout” function may not work due to
abnormal activities of some network application software,
computer virus or hacker attacks from the Internet. For
example, some software sends network packets to the
Internet in the background, even when you are not using the
Internet. So please turn off your computer when you are not
using it. This function also may not work with some ISP. So
please make sure this function can work properly when you
use this function in the first time, especially your ISP charge
you by time used.
Click <
OK>
when you have finished the configuration above.
Congratulations
! You have completed the
configuration for the L2TPP connection.