1. Home
    2. /
  2. Manuals
    3. /
  3. Cisco
    4. /
  4. RV042G
    5. /
  5. 5
Page 21 / 199 Scroll up to view Page 16 - 20
Viewing System Summary Information
Cisco Small Business RV0xx Series Routers Administration Guide
21
2
System Information
This section includes the following information:
•
Serial Number:
The serial number of the router.
•
Firmware version:
The current version number of the firmware installed on
the router.
•
PID VID:
The current version number of the hardware.
•
MD5 Checksum:
A value used for file validation.
•
LAN IP / Subnet mask:
The current IP Address of the router on the local
network.
•
Working Mode:
The working mode (Gateway or Router).
•
LAN:
If Dual-Stack IP is enabled, on the
Setup > Network
page, this section
displays the IPv4 address and subnet mask as well as the IPv6 address and
prefix length.
•
System Up time:
The length of time in days, hours, and minutes that the
router has been active.
Cisco ProtectLink Web
This section displays buttons for the optional Cisco ProtectLink Web service.
ProtectLink Web provides security for your network. It filters website addresses
(URLs) and blocks potentially malicious websites. (Also see
Chapter 8, “Getting
Started with Cisco ProtectLink Web.”
)
NOTE
This service is not available on Cisco RV042G.
You can use the following buttons:
•
Go buy:
Click this button to purchase a license to use this service. You will
be redirected to a list of Cisco resellers on the Cisco website. Then follow
the on-screen instructions.
•
Register:
Click this button if you have a license but have not yet registered
it. You will be redirected to the Cisco ProtectLink Web website. Then follow
the on-screen instructions.
•
Activate:
Click this button if you have registered for Cisco ProtectLink Web
service and wish to activate it. You will be redirected to the Cisco
ProtectLink Web website. Follow the on-screen instructions.
NOTE
If the Cisco ProtectLink Web options are not displayed on the
System Summary
page, you can upgrade the router’s firmware to enable this feature.
Page 22 / 199
Viewing System Summary Information
Cisco Small Business RV0xx Series Routers Administration Guide
22
2
Configuration
If you need help to configure the router, click
Setup Wizard
. You can then use
these wizards:
•
Basic Setup Wizard:
Use this wizard to set up your Internet connection.
•
Access Rule Setup Wizard:
Use this Wizard to set up the security policy
for your VPN.
Port Statistics
This table shows the status and available statistics for each port. It also provides
access to detailed information about current link activity.
•
Port ID:
The port label.
•
Interface:
The type of interface, such as LAN, WAN, or DMZ. Multiple WAN
interfaces are indicated by a number, such as WAN1 or WAN2.
•
Status:
The status of the port:
Disabled
(red),
Enabled
(black), or
Connected
(green). The status is a hyperlink that you can click to open the
Port Information
window.
Port Information Window
If you click a status in the
Port Statistics
table, the
Port Information
window
appears. This window displays the latest information about the interface
and the current activity. To update the displayed information, click the
Refresh
button. To close the window, click the
Close
button.
Page 23 / 199
Viewing System Summary Information
Cisco Small Business RV0xx Series Routers Administration Guide
23
2
This window displays the following information:
-
Type:
The type of port, 10Base-T/100 Base-TX.
-
Interface:
The type of interface, such as LAN, DMZ, or WAN.
-
Link Status:
The current status of the link:
Up
or
Down
.
-
Port Activity:
The current activity on the port, either Port Enabled, Port
Disabled, or Port Connected.
-
Priority:
The priority setting, High or Normal.
-
Speed Status:
The speed, 10Mbps or 100Mbps.
-
Duplex Status:
The duplex mode, Half or Full.
Page 24 / 199
Viewing System Summary Information
Cisco Small Business RV0xx Series Routers Administration Guide
24
2
-
Auto negotiation:
The auto negotiation setting, On or Off.
-
VLAN:
The VLAN ID.
-
Receive Packet Count:
The number of packets received through this
port.
-
Receive Packet Byte Count:
The number of bytes received through this
port.
-
Transmit Packet Count:
The number of packets transmitted through
this port.
-
Transmit Packet Byte Count:
The number of bytes transmitted through
this port.
-
Packet Error Count:
The number of packet errors.
WAN Status
This section displays information for the WAN1 interface as well as DMZ or WAN2,
depending on your configuration. On Cisco RV016, additional WAN interfaces may
be configured. Use the tabs to view the IPv4 and IPv6 information.
NOTE
The IPv6 tab is available if Dual-Stack IP is enabled on the
Setup > Network
page.
•
WAN information:
-
IP Address:
The current public IP address for this interface.
-
Default Gateway:
The default gateway for this interface.
-
DNS:
The IP address of the DNS server for this interface.
-
Dynamic DNS (IPv4 only):
The DDNS settings for this port, Disabled or
Enabled.
-
Release
and
Renew:
These buttons appear if the port is set to obtain an
IP address automatically. Click
Release
to release the IP address, and
click
Renew
to update the DHCP lease time or to get a new IP address.
-
Connect
and
Disconnect:
These buttons appear if the port is set to
PPPoE or PPTP. Click
Disconnect
to disconnect from the Internet
service. Click
Connect
to re-establish the connection.
Page 25 / 199
Viewing System Summary Information
Cisco Small Business RV0xx Series Routers Administration Guide
25
2
•
DMZ information:
-
IP Address:
The current public IP address for this interface.
-
DMZ Host:
The DMZ private IP address of the DMZ host. The default is
Disabled
.
Firewall Setting Status
This section displays the following information:
•
SPI (Stateful Packet Inspection):
The status of this feature:
On
(green) or
Off
(red).
•
DoS (Denial of Service):
The status of this feature,
On
(green) or
Off
(red).
•
Block WAN Request:
The status of this feature,
On
(green) or
Off
(red).
•
Remote Management:
The status of this feature,
On
(green) or
Off
(red).
•
Access Rule:
The number of access rules that have been set.
VPN Setting Status
This section displays the following information:
•
Tunnel(s) Used:
The number of VPN tunnels in use.
•
Tunnel(s) Available:
The number of VPN tunnels available.
Log Setting Status
This section displays the following information:
•
Syslog Server:
The status of the syslog server,
On
(green) or
Off
(red).
•
Email Log:
The status of the email log,
On
(green) or
Off
(red).

Rate

4 / 5 based on 1 vote.

Popular Cisco Models

Famous Router IPs
Famous Router Companies
Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top