Page 31 / 84
Scroll up to view Page 26 - 30
31
By default, the AirStation receives RIP
(Route Information Protocol) informa-
tion only from your local network, and
doesn’t broadcast RIP at all.
For large,
complicated network configurations,
you may wish to modify this behavior.
Click
Apply
when you have your desired
configuration.
Lower on the page, routing information
is displayed.
Click
Edit Routing Informa-
tion
to add a new route manually.
Network Config (Route Info)
Page 32 / 84
32
To configure a route manually, enter its
Destination Address
and
Gateway
.
Enter
a maximum number of hops allowable in
Metric
and click
Add
.
Network Configuration (Edit Routing Information)
Page 33 / 84
33
NAT
You may disable Network Address
Translation and IPsec passthrough by
unchecking the appropriate
Enable
boxes.
If you have a DMZ, enter its IP address
in the
IP Address of DMZ
box.
Incoming
packets containing no recognizable
destination port information will be
redirected to the DMZ’s IP address.
Click
Apply
when done.
To set a NAT table entry manually, click
Edit NAT Table
.
Page 34 / 84
34
NAT (Manual Entry)
From this page you may manually add
entries into the Address Translation
Table.
Click
Add
New Group
when each is
complete.
Page 35 / 84
35
Your AirStation comes pre-configured
with basic rules.
You may choose which
of these to use by clicking on
Add/Delete
Basic Rules
and turning to page 36.
To make a custom rule, click on
Configure
IP Filter
(page 37).
IP Filter
19216811.live