Page 6 / 48
Scroll up to view Page 1 - 5
µ
Wall Mounting
4.5 cm (~1.75 inches)
8.5 cm
(~3.3 inches)
F
or wall mounting, screw two of the included wall-mounting screws into the wall in either
of the configurations shown below. Slots on the back of the AirStation will fit over a pair of
screws in either configuration.
Page 7 / 48
¶
Wall Mounting
O
r, the base can be attached directly to the wall with two screws 8.5 cm (~3.3”) apart. After
the base is firmly secured, attach the AirStation to its base normally.
8.5 cm
(~3.3 inches)
Page 8 / 48
·
Connecting your AirStation
PC
Cable or DSL Modem
Power to outlet or
surge protector
Router switch should
be set to
Auto
for
normal use.
Page 9 / 48
¸
To initially configure your AirStation, you’ll use a wired connection to your computer.
Once you’ve connected to the internet through the router, you may switch to a wireless
connection if desired.
The computer used to configure the AirStation should be set to obtain an IP address
automatically using a DHCP server (this is the default). The WHR-G300N has a default
LAN IP address of
192.168.11.1* and Subnet Mask of 255.255.255.0.
1. Power down the Cable or DSL modem and the computer which will be used to
configure the AirStation router.
2. Plug the Cable or DSL modem’s Ethernet cable into the AirStation’s WAN port.
Initially, you may need to unplug this cable from your computer, hub or other router.
3. Plug the provided Ethernet cable into one of the four LAN ports on the AirStation and
plug the other end into your computer’s Ethernet adapter (NIC).
4.
Important:
turn everything on in the correct order!!
Power on your cable or DSL modem
and wait one full minute, then power on the AirStation and wait one full minute, and
finally power on the computer which will be used to configure the AirStation.
Setup
Page 10 / 48
10
L
aunch a web browser on the computer that you’re
using to configure the AirStation.
Enter
192.168.11.1
into the URL field. Naturally, if you
change your AirStation’s IP address, you’ll have to enter
the new address instead.
A window will open, prompting you to enter a User ID
and Password.
Enter
root
as the User name and leave the password
field
blank
.
Log in to the Configuration Tool
19216811.live