User Manual v1.1

Page 46

of 50

4.

Enter

the

Domain

Name

that

you

received

from

the

Dynamic

DNS

provider

(xxx.domainmame.com). Click Apply for the settings to take effect.

System

System Information

This section shows the current firmware information and the router’s MAC addresses.

Settings

This section allows you to Back up, Save and Restore to factory default the router’s configuration.

User Manual v1.1

Page 47

of 50

Backup

Click the ‘Backup’ button to save the current settings of your router. If you will change the current

configuration of your HW550-3G it is recommended that you backup the router’s current settings.

Restore

Click the browse button and select the saved configuration setting of the router then click

‘Restore’. This allows you to load the restored configuration file of your router.

Restore to factory default

Click the ‘Reset” button to reset the router’s configuration back to its Factory Default settings.

Firmware Upgrade

This section allows you to upload the latest firmware for your router. Please make sure that you

download the correct firmware from the product support website.

Reboot

Click the ‘Reboot’ button to reboot the device

User Manual v1.1

Page 48

of 50

Password

This section allows you to change the default password setting of the router to access the Web

GUI.

1.

Enter the new password on the required field then click Apply.

2.

Once the setting is applied, on the authentication login page enter the Username and new

Password to access the router’s WEB UI.

User Manual v1.1

Page 49

of 50

Regulatory Compliance Notices

FCC Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15, 22 and 24 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

•

Consult the dealer or an experienced radio or television technician for help.

Modifications

Modifications

Modifications

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are not

expressly approved by Aztech could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC ru

This device complies with Part 15 of the FCC ru

This device complies with Part 15 of the FCC ru

This device complies with Part 15 of the FCC rules.

les.

les.

les.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1.

This device may not cause harmful interference, and

2.

This device must accept any interference received, including interference that may cause

undesired operation.

Exposure Information to Radio Frequency Energy

Exposure Information to Radio Frequency Energy

Exposure Information to Radio Frequency Energy

Exposure Information to Radio Frequency Energy

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance of 20 cm between the radiator and

your body.

User Manual v1.1

Page 50

of 50

European Regulations

The product has been designed, tested and manufactured according to the European R&TTE directive

1999/5/EC.