Page 46 / 58 Scroll up to view Page 41 - 45
RT-N1±
Chapter ³: Troubleshooting
Problem
Action
How to restore the system to
its default settings?
Press the Restore button at the rear panel
of the wireless router for more than five
seconds.
Refer to the section
Restoring/Saving/
Uploading settings
in Chapter 4 of this
user manual.
The following are the factory default settings:
User Name:
admin
Password:
admin
Enable DHCP:
Yes (if WAN cable is plugged in)
IP address:
19±.1³8.1.1
Domain Name:
(Blank)
Subnet Mask:
±55.±55.±55.0
DNS Server 1:
19±.1³8.1.1
DNS Server 2:
(Blank)
SSID:
ASUS
I cannot use 19±.1³8.1.1 to
enter the web GUI.
Check the router’s operation mode.
In the Router mode, the default IP address
is 19±.1³8.1.1.
In the Repeater / AP mode, use Device
Discovery to find the router’s IP address.
Downloaded from
www.Manualslib.com
manuals search engine
Page 47 / 58
47
Chapter ³: Troubleshooting
RT-N1±
ASUS DDNS Service
RT-N1± supports the ASUS DDNS service. When exchanging devices at the
service center, if you have registered the ASUS DDNS service and want to keep
the original domain name, data transfer is a must. Visit your local service center for
more information.
Notes
:
• If there is no activity in the domain - such as reconfiguring the router or accessing the
registered domain name - within 90 days, the system automatically deletes the registered
information.
• If you encounter any problem or difficulty in using your device, contact the service center.
Frequently Asked Questions (FAQs)
1.
Will the registered information be lost or registered by others?
If you have not updated the registered information in 90 days, the system
automatically deletes the registered information and the domain name may be
registered by others.
2.
I did not register the ASUS DDNS for the router I bought six months ago.
Can I still register it?
Yes, you can still register the ASUS DDNS service for your router. The DDNS
service is embedded in your router, so you can register the ASUS DDNS
service anytime. Before registering, click
Query
to check if the hostname has
been registered or not. If not, the system registers the hostname automatically.
3.
I have registered a domain name before and it has been working well until
my friends told me that they could not access my domain name.
Check the following:
1. The internet is working well.
±. The DNS server is working well.
². The last time you updated the domain name.
If there are still problems in accessing your domain name, contact the service
center.
4.
Can I register two domain names to separately access my http and ftp
servers?
No, you cannot. You can only register one domain name for one router. Use
port mapping to implement security in the network.
Downloaded from
www.Manualslib.com
manuals search engine
Page 48 / 58
48
RT-N1±
Chapter ³: Troubleshooting
5.
After restarting the router, why is it that I see different WAN IPs in MS
DOS and in the router configuration page?
This is normal. The interval time between the ISP DNS server and ASUS
DDNS results in different WAN IPs in MS DOS and in the router configuration
page. Different ISPs may have different interval time for IP updating.
6.
Is the ASUS DDNS service free, or is it just a trial version?
The ASUS DDNS service is a free and embedded service in some ASUS
routers. Check your ASUS router if it supports the ASUS DDNS service.
Downloaded from
www.Manualslib.com
manuals search engine
Page 49 / 58
49
Appendices
RT-N1±
Notices
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Prohibition of Co-location
This device and its antenna(s) must not be co-located or operating in conjunction
with any other antenna or transmitter.
Safety Information
To maintain compliance with FCC’s RF exposure guidelines, this equipment should
be installed and operated with minimum distance ±0cm between the radiator and
your body. Use on the supplied antenna.
Appendices
Downloaded from
www.Manualslib.com
manuals search engine
Page 50 / 58
50
RT-N1±
Appendices
Declaration of Conformity for R&TTE directive 1999/5/EC
Essential requirements – Article ²
Protection requirements for health and safety – Article ².1a
Testing for electric safety according to EN ³0950-1 has been conducted. These are
considered relevant and sufficient.
Protection requirements for electromagnetic compatibility – Article ².1b
Testing for electromagnetic compatibility according to EN ²01 489-1 and EN ²01
489-17 has been conducted. These are considered relevant and sufficient.
Effective use of the radio spectrum – Article ².±
Testing for radio test suites according to EN ²00 ²±8- ± has been conducted.
These are considered relevant and sufficient.
CE Mark Warning
This is a Class B product, in a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.
Operation Channels: Ch1~11 for N. America, Ch1~14 Japan, Ch1~1² Europe
(ETSI)
IC Warning
The Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulation.
Cet appareil numerique de la class B respecte toutes les exigences du Reglement
sur le materiel brouilleur du Canada.
GNU General Public License
Licensing information
This product includes copyrighted third-party software licensed under the terms of
the GNU General Public License. Please see The GNU General Public License
for the exact terms and conditions of this license. We include a copy of the GPL
with every CD shipped with our product. All future firmware updates will also
be accompanied with their respective source code. Please visit our web site for
updated information. Note that we do not offer direct support for the distribution.
GNU GENERAL PUBLIC LICENSE
Version ±, June 1991
Copyright (C) 1989, 1991 Free Software Foundation, Inc.
59 Temple Place, Suite ²²0, Boston, MA 0±111-1²07 USA
Everyone is permitted to copy and distribute verbatim copies of this license
document, but changing it is not allowed.
Downloaded from
www.Manualslib.com
manuals search engine

Rate

3.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top