Page 51 / 54
Scroll up to view Page 46 - 50
DSL-N13 Wireless ADSL 2/2+ Modem Router User Manual
4±
5.
Input the IP address of DSL-N13 in
the
Printer Name of IP Address
field and click
Next
.
6. Select
Custom
and click
Settings...
7. Set
Protocol
to
LPR
and type
LPRServer
in
Queue Name
field.
Click
Next
to continue.
8. Press
Next
to finish standard TCP/
IP port setting.
9. Press
Finish
to complete the
settings and return to Add Printer
Wizard.
10. Install printer driver from the vendor-
model list. If your printer is not in
the list, click
Have Disk
to manually
assign the location of driver.
Page 52 / 54
DSL-N13 Wireless ADSL 2/2+ Modem Router User Manual
50
11. Click
Next
to accept the default name
for the printer.
12. Select
Yes
to print a test page. Click
Next
to print.
13. The installation is complete. Click
Finish
to quit the Add Printer Wizard.
If you use Windows
®
98 or ME which does not support Standard TCP/IP
port, you need to use Romote Port which is supported by DSL-N13.
If you have already installed the printer locally on your computer, right click
the printer icon and select
Property
-> Port
tab to add a standard TCP/IP
port. Click
Add Port
then select
Standard TCP/IP Port
and click
New Port
button. Refer to Step 5-8 for setting procedures.
Page 53 / 54
DSL-N13 Wireless ADSL 2/2+ Modem Router User Manual
51
This chapter describes how to maintain your DSL-N13 wireless ADSL router.
Configuration backup
You can backup the configuration to a file and store it on your computer. Click
Management -> Settings
to open the configuration page and click the
Backup
Settings
button. Click
Save
and define the destination folder. The default name for
backup file is
backupsettings.conf
.
Management
Restore settings from a backup file
You can restore the settings from a backup file when you have reset the wireless router
to factory default. Click
Management -> Settings -> Update
to open the configuration
page. Click
Browse...
to locate the backup file on your computer, then click
Update
Settings
button to proceed. When restoring is complete, the wireless router reboots.
The whole process takes about 80 seconds.
Reset to factory default
If you want to clear all settings and return to the factory default settings. You can press
the
Reset
button on the rear panel of the wireless router for 10 seconds; or click
Management -> Settings -> Restore Default
to open the configuration page and click
the
Restore Default Settings
button.
Page 54 / 54
DSL-N13 Wireless ADSL 2/2+ Modem Router User Manual
52
Setting up time server
You can configure the time setting so that DSL-N13 can always synchronize with a time
server from Internet. Click
Management -> Time settings
and check
Automatically
synchronize with International servers
. Select a time server from the drop-down list
and set your time zone. When finished, click
Save/Apply
.
Firmware update
To update firmware, click M
anagement -> Update Software
. Click
Browse...
to locate
the firmware file, then click
Update Software
button to start uploading the firmware.
The update process takes about two minutes.
19216811.live