Page 11 / 59
Scroll up to view Page 6 - 10
150Mbps Wireless Broadband Router
User Manual
9
Rear panel
2.3.
Restore to factory configuration
If the router ever freezes in a setting change process or if you can’t access it because you can’t
remember the IP you have given it or other problem, you may have to utilize the reset button on
the back of the router to put it back to factory settings. You have to press and hole this button
for a few seconds (2-6s) with a pencil when it is working, then release and it will restore
settings to the factory configuration.
The other way to restore factory settings is through the same user interface used in setup.
Click on ‘System management’- ‘Restore’, and click on the ‘Restore’ button.
2.4.
Hardware Installation Procedures
The procedures to install the 150Mbps Wireless Broadband Router please refers to the
following picture
Description
Function
PWR
Connect to Power adapter, please don’t use the unknown
power adapter, otherwise your device may be damaged.
LAN 1-4
Connect with computer NIC or Ethernet device
WAN
Internet access
Reset
Restore settings
Page 12 / 59
150Mbps Wireless Broadband Router
User Manual
10
Attach one end of an Ethernet cable to your computer’s Ethernet port, and the other end to
one of the LAN ports of your router.
Connect another Ethernet cable from your Cable/DSL modem to the WAN port of your
router.
Connect the single DC output connector of the power adapter to the power jack on the back
of the router and plug the Power Adapter into an AC outlet.
Page 13 / 59
150Mbps Wireless Broadband Router
User Manual
11
3.
Login
You can manage the 150Mbps Wireless Broadband Router through the Web browser-based
configuration utility. To configure the device via Web browser, at least one properly configured
computer must be connected to the device via Ethernet or wireless network. The 150Mbps
Wireless Broadband Router is configured with the
and
subnet mask of 255.255.255.0
and its
DHCP server is enabled by default
. Before setting up
the Router, make sure your PCs are configured to obtain an IP address automatically from the
Router by the steps below.
3.1.
Configure computer
3.1.1.
Windows XP
Please follow the steps below to setup your computer:
1. Go to Start
Settings
Control Panel.
2. Click Network and Internet Connections.
3. Click Network Connections.
Page 14 / 59
150Mbps Wireless Broadband Router
User Manual
12
4. Highlight the icon Local Area Connection, right click your mouse, and click Properties.
5. Highlight Internet Protocol (TCP/IP), and then press Properties button.
Page 15 / 59
150Mbps Wireless Broadband Router
User Manual
13
6. Choose Obtain an IP address automatically and Obtain DNS server address automatically,
and then press OK to close the Internet Protocol (TCP/IP) Properties window.
7. Press OK to close the Local Area Connection Properties window.
19216811.live