TP-Link TD-W8961N Router Manual PDF (Setup & Configuration Guide)

Given below is full router user manual of TP-Link TD-W8961N router model. You can also download this manual in PDF Format to read later on your computer.

Product user manuals come handy in case you want to know all functionalities of your device, troubleshooting, fist time configuration & setup and in many other situations.

Page 1 / 78
TD-W8961N
300Mbps Wireless N ADSL2+ Modem Router
Rev: 1.0.0
1910010964
Page 2 / 78
COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice.
is a registered trademark
of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or
registered trademarks of their respective holders.
No part of the specifications may be reproduced in any form or by any means or used to make any
derivative such as translation, transformation, or adaptation without permission from TP-LINK
TECHNOLOGIES CO., LTD. Copyright © 2013 TP-LINK TECHNOLOGIES CO., LTD. All rights
reserved.
Page 3 / 78
FCC STATEMENT
This equipment has
been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1)
This device may not cause harmful interference.
2)
This device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operating in conjunction with
any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is applicable to only
Mobile Configurations. The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.”
Page 4 / 78
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio interference, in
Canadian Compliance Statement
exempt RSS standard(s). Operation is subject
erference, and
luding interference that may cause undesired
me aux norms CNR exemptes de licence d’Industrie Canada. Le
is celles susceptibles de provoquer un
Industry Canada Statement
cifications.
NMB-003 du Canada.
s all the
du Règlement sur le
Korea Warning Statements:
있음.
NCC Notice & BSMI Notice
電波輻射性電機管理辦法
電機,非經許可,公司、商號或使用者均不得擅自變更頻
which case the user may be required to take adequate measures.
This device complies with Industry Canada license-
to the following two conditions:
(1) This device may not cause int
(2)This device must accept any interference, inc
operation of the device.
Cet appareil est confor
fonctionnement est soumis aux deux conditions suivantes:
(1) cet appareil ne doit pas provoquer d’interférences et
(2) cet appareil doit accepter toute interférence, y compr
fonctionnement non souhaité de l’appareil.
Complies with the Canadian ICES-003 Class B spe
Cet appareil numérique de la classe B est conforme à la norme
This device complies with RSS 210 of Industry Canada. This Class B device meet
requirements of the Canadian interference-causing equipment regulations.
Cet appareil numérique de la Classe B respecte toutes les exigences
matériel brouilleur du Canada.
당해
무선설비는
운용중
전파혼신
가능성이
注意!
依據 低功率
第十二條 經型式認證合格之低功率射頻
率、加大功率或變更原設計之特性或功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通行;經發現有干擾現象時,應立
即停用,並改善至無干擾時方得繼續使用。前項合法通信,指依電信規定作業之無線電信。低功率
Page 5 / 78
安全諮詢及注意事項
只能按照本產品注明的電源類型使用本產品。
清潔。
過熱,請勿堵塞或覆蓋開口。
UkrSEPRO
射頻電機需忍受合法通信或工業、科學以及醫療用電波輻射性電機設備之干擾。
●請使用原裝電源供應器或
●清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行
●注意防潮,請勿將水或其他液體潑灑到本產品上。
●插槽與開口供通風使用,以確保本產品的操作可靠並防止
●請勿將本產品置放於靠近熱源的地方。除非有正常的通風,否則不可放在密閉位置中。
●請不要私自打開機殼,不要嘗試自行維修本產品,請由授權的專業人士進行此項工作。
Продукт
сертифіковано
згідно
с
правилами
системи
УкрСЕПРО
на
відповідність
вимогам
нормативних
документів
та
вимогам
,
що
передбачені
чинними
законодавчими
актами
України
.
Safety Information
button, the power button is one of the way to shut off the product;
elf. You run the risk of electric shock
wing countries:
DE
DK
EE
When product has power
when there is no power button, the only way to completely shut off power is to disconnect the
product or the power adapter from the power source.
Don’t disassemble the product, or make repairs yours
and voiding the limited warranty. If you need service, please contact us.
Avoid water and wet locations.
This product can be used in the follo
AT
BG
BY
CA
CZ
ES
FI
FR
GB
GR
HU
IE
IT
LT
LV
MT
NL
NO
PL
PT
RO
RU
SE
SK
TR
UA

Rate

4 / 5 based on 1 vote.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top