Page 11 / 80 Scroll up to view Page 6 - 10
10
LED States
Service Status LED
LED Color
Status
Description
No light
Off, and the
Power Button
LED is also off
The device is powered off or otherwise is not getting
power.
No light
Off; the Power
Button LED is
pulsing GREEN
The device is in low-power Standby mode. [See
Power
Management
(page 59).
] This means the device is charging
while connected to a computer, but the device is not
connected to the network.
GREEN
Solid
Slow blinking
Intermittent
blinking
The device is powered on but is not transmitting or
receiving data.
The device is on and searching for a network, and does not
have service.
The device is transmitting or receiving data. The blink rate
is proportional to the data speed.
Power Button LED
LED Color
Status
Description
No Light
Off
The device is powered off or otherwise is not getting power.
BLUE
Solid
The device is powered on and roaming.
GREEN
Solid
Pulsing
The device is powered on and fully charged.
The device is in low-power Standby mode. [See
Power
Management
(page 59).
]
Red
Blinking
The battery is critically low.
Amber
Solid
Pulsing
The battery is charging.
The device has an error. [See
Troubleshooting
(page 60).
]
Page 12 / 80
11
Power Management
Your device will work from its battery or when plugged into a power source.
Battery
— The battery lasts for up to four hours. Charge the battery by plugging in the AC
adapter. While the battery is charging the Power Button LED is solid amber. When the battery
is fully charged, the LED is solid green.
Wall power
— You can use the device when it is plugged into a wall socket. The MiFi battery
charges while it is plugged in.
USB power from a computer
— You can use the device as a USB modem while plugged into
the USB port of a computer, using the supplied microUSB cable. The battery charges while it
is plugged in. Charging the battery through the USB port is slower than charging it with wall
power.
NOTE 
You cannot use MiFi in WiFi mode while it is plugged into a USB port.
Before using MiFi 2200, read the battery safety information in the “Safety Hazards” section of this
guide. [See
Proper Battery Use and Disposal
(page 72).
]
Page 13 / 80
12
Battery Tips
WARNING !
Use only batteries and chargers with your device that have been approved by
your service provider or by Novatel Wireless. Always use Novatel Wireless original batteries and
chargers. The warranty does not cover damage caused by non-Novatel Wireless batteries and/or
chargers.
It normally takes at least four hours to fully charge the battery.
Do not use sharp objects to access the battery well, this may damage the device and the
battery.
Do not use excessive force to remove the battery or to access the battery well.
If your MiFi device is connected to a computer using a USB cable, the battery charges.
When one device is accessing mobile data while your MiFi device is using battery power, the
device lasts up to four hours.
The battery discharges more rapidly as additional devices access your MiFi device.
Battery life depends on the network, signal strength, temperature, features, and accessories
you use.
Your device also works with an approved car charger.
New batteries or batteries stored for a long time may take more time to charge.
When charging your battery, keep it near room temperature.
When storing your battery, keep it uncharged in a cool, dark, dry place.
Never expose batteries to temperatures below -10°C (14°F) or above 45°C (113°F).
Never leave the device in an unattended vehicle due to uncontrollable temperatures that
may be outside the desired temperature for this device.
Some batteries perform best after several full charge/discharge cycles.
It is normal for batteries to gradually wear down and require longer charging times. If you
notice a change in your battery life, it is probably time to purchase a new battery.
IMPORTANT
Whenever you remove or insert either the battery or the SIM card, ensure your
MiFi device is not connected to any device or power source. Never use tools, knives, keys, pens or
any type of object to force the door open or to remove the battery. Using any of these types of
objects could result in puncturing the MiFi battery.
WARNING !
The failure to use approved batteries and chargers may increase the risk that your
device will overheat, catch fire, or explode, resulting in serious bodily injury, death, or property
damage. To avoid risk of explosion, never dispose of batteries in a fire.
Page 14 / 80
13
Caring for Your Device
Like any electronic device, the device must be handled with care to ensure reliable operation.
Verizon Wireless recommends the following guidelines:
Protect the device from liquids, dust, and excessive temperatures.
Do not apply adhesive labels to the device; they might cause the device to potentially
overheat and they might alter the performance of the antenna.
The USB connector should plug easily into your computer’s standard Type A USB port. Do not
force the device into a port, as doing so might damage the connector.
Remove the device from your computer before transporting it.
Store the device in a safe place when not in use.
Page 15 / 80
Accessing the Network
Using the Device for the First Time
Configuring WiFi Mode
Using the Device After Setup is Complete
Accessing the User Guides
Using MiFi 2200
2

Rate

3.5 / 5 based on 2 votes.

Popular Samsung Models

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top