5
Product Overview
Linksys X2000/X3000
Back
DSL
—Connects to the ADSL line°
Cable
—To use the modem router as only a router, use a
network cable to connect this port to a separate modem’s
LAN/Ethernet port°
Ethernet
—Using Ethernet cables (also called network
cables), these Ethernet ports connect the modem router
to computers and other Ethernet network devices on your
wired network°
Power
—The Power port connects to the included power
adapter°
Power button
—Press
|
(on) to turn on the modem router°
(Button not available on North American models°)
Bottom
Reset
—This button allows you to reset the router to
its factory defaults° Press and hold the Reset button for
approximately five seconds°
Wall-mounting placement
The router has two wall-mount slots on its bottom panel° The distance between
the slots is 175°56 mm° Two screws are needed to mount the router°
Suggested Mounting Hardware
2°5-3°0 mm
4-5 mm
1-1°5 mm
NOTE
Cisco is not responsible for damages incurred by unsecured wall-
mounting hardware°
Follow these instructions:
1.
Determine where you want to mount the router° Make sure that the wall
you use is smooth, flat, dry, and sturdy° Also make sure the location is
within reach of an electrical outlet°
2.
Drill two holes into the wall° Make sure the holes are 175 mm apart°
3.
Insert a screw into each hole and leave 3 mm of its head exposed°
4.
Position the router so the wall-mount slots line up with the two screws°
5.
Place the wall-mount slots over the screws and slide the router down
until the screws fit snugly into the wall-mount slots°
175 mm
Wall-mounting template
Print this page at 100% size°
Cut along the dotted line, and place on the wall to drill precise spacing°
19216811.live