Page 6 / 12
Scroll up to view Page 1 - 5
1.5 System Requirements
The ZXHN F668 system requirements are as follows:
•
An optical fibre connection to the GibFibreSpeed Network.
•
A device installed with a 10 Mbps/100 Mbps/1000 Mbps Ethernet interface
or an 802.11b/g/n wireless card is needed.
•
A Web browser, such as Chrome, IE, Mozilla Firefox, Opera, etc.
1.6 Hardware Connection
Figure 1-4 shows the entire connections between the ZXHN F668 and other devices.
Figure 1-4 Hardware Connections
-
Figure 1-5 shows
how to connect the power supply to the ZXHN F668.
Figure 1-5 Power Supply Connection
Page 6
Page 7 / 12
Figure 1-6 shows the optical fibre cable connecting to the ZXHN F668 PON interface.
Figure 1-6 PON Connection
Use a RJ-45 network cable to connect the computer or the IPTV STB with the
ZXHN F668, as shown in Figure 1-7.
Figure 1-7 LAN Interface Connection
Page 7
Page 8 / 12
Use a RJ-11 cable to connect a phone to the ZXHN F668, as shown below.
Figure 1-8 Telephone Connection
Use the special power cable to monitor the battery, (Optional and not supplied with
F668).
Figure 1-9 Battery Connection
Page 8
Page 9 / 12
A USB storage device is connected to the ZXHN F668, as shown below.
Figure 1-10 USB Storage Device Connection
Press the button to power ON the ZXHN F668, as shown below. The POWER LED,
PON LED, LAN LED (if device connected), and POTS LED (if device connected) should
be ON. This indicates that all services are running normally.
Figure 1-11 Power On
Page 9
Page 10 / 12
2. Configuration Preparation
2.1 Preliminary Set-up
The GibFibreSpeed Network Access team will set-up and configure the F668
remotely.
The F668 has a default Wi-Fi SSID and WAP-PSK, which can be found on a label
attached underneath the unit. The SSID and WPA-PSK can be change for, or by, the
client if required.
2.2 Logging in to the Device
Perform this procedure to log in to the device.
Prerequisites
Ensure all optical fibre and LAN cables are connected properly to the F668 and a
computer or other device is correctly configured.
1.
IP
address of the
device) in to the URL address bar and press
Enter
.
The login dialog box is displayed, as shown in Figure 2-1.
Enter the
Username
and
Password
(by default, both are admin ).
Click
Login
to open the main window.
Figure 2-1 Login Window
2-6
Page 10
19216811.live