4

4.

Click

Discovery

, and then double-click the

Switch

that appears in the

Discovery List

.

5.

Click the

Switch

in the

Monitor List

and then

click

Configuration setting

.

7.

Click

OK

.

6.

Configure the

IP Address

,

Subnet mask

,

Gateway

, and

Password

. Click

Set

.

5

8.

Click

Access Web

.

9.

Type in your

Password

and then click

Login

.

By default, the Password is

admin

.

Your installation is now complete.

For detailed information regarding the

Web-based Smart Utility

configuration and advanced

settings, please refer to the Troubleshooting section, User's Guide on the Utility CD-ROM, or

TRENDnet's website at http://www.trendnet.com.

Register Your Product

To ensure the highest level of customer service and support, please take a moment to

register your product Online at:

www.trendnet.com/registe

r

Thank you for choosing TRENDnet

1.

1.

After connecting the TEG-160WS/TEG-240WS to a power outlet, the LEDs do

not turn on.

Check the connection of the power cord to the TEG-160WS/TEG-240WS and the

power outlet. Also check that the power outlet is receiving power.

2. After installing the Web-Management Utility, I clicked Discovery and the Utility

is unable to discover the TEG-160WS/TEG-240WS. What should I do?

Make sure that the TEG-160WS/TEG-240WS is powered on and that all

connections are secure.

2. Also check that your computer's IP Address is on the same network segment as

the TEG-160WS/TEG-240WS. The default IP Address of the

TEG-160WS/TEG-240WS is

and the default password is

"admin".

3. When I access the TEG-160WS/TEG-240WS using a web browser, I get a screen

that tells me “only one user can login”. What should I do?

Another computer is configuring the TEG-160WS/TEG-240WS.

Please wait until

the user logs off. If the other user has already logged off and you still get the same

screen, then disconnect the power cord from the TEG-160WS/TEG-240WS, wait

for 5 seconds, reconnect the power cord to the TEG-160WS/TEG-240WS, allow 5

seconds for the Switch to power on, and then attempt to access the web

configuration page to login.

4. I forgot the administration password.

How do I reset my TEG-160WS/TEG-

240WS?

Press on the reset button using a pen or paperclip for 10 seconds.

The default

password is

admin

.

5.When I connect a computer to the Switch's gigabit port, the LINK/ACT LED turns

on, but the 1000Mbps (TEG-160WS) or the SPEED (TEG-240WS) LED remains off.

1.

For the TEG-160WS, when the 1000Mbps LED remains off, the computer's

connection speed is 10Mbps or 100Mbps (if the 100Mbps LED is on).

2. For the TEG-240WS, if the SPEED LED is off, the computer's connection speed is

10Mbps.

When the SPEED LED is yellow, the computer's connection speed is

100Mbps.

Make sure that you have a Gigabit Ethernet adapter installed.

Also

make sure to use a Cat-5e or Cat 6 Ethernet cable.

If you still encounter problems or have any questions regarding the TEG-160WS/TEG-

240WS, please refer to the User's Guide included on the Utility CD-ROM or contact

Trendnet's Technical Support Department.

Troubleshooting

6

Copyright ©2010. All Rights Reserved. TRENDnet.