Q1.
A1.
Q2.
A2.
Q3.
A3.
How come I cannot see any light from any of my LED's?
Your TE100-S800i/TE100-S810Fi
is not getting any power.
Make
sure that your surge protector or your outlet is getting power and make
sure that the AC Power cord is properly connected to your
TE100-S800i/TE100-S810Fi.
I changed my IP settings to
192.168.16.222 to access the switch, but I
still cannot get into the Web configuration page.
What should I do?
Make sure there is no other network device using the same IP
address.
Afterwards, consult the User's Guide to access the switch
through the Console Port.
Once you reach the command line interface,
perform a factory reset and try again.
I performed a factory reset on the TE100-S800i/TE100-S810Fi, but I
still cannot access the web configuration page.
What should I do?
If you are configuring more than one TE100-S800i/TE100-S810Fi,
then it is possible that you are experiencing IP conflict between these two
switches.
Please configure each switch one at a time, and make sure you
assign a unique IP address to each switch.
If you have any questions regarding the TE100-S800i/TE100-S810Fi, please
contact TRENDnet Technical Support Department.
5
Troubleshooting
Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received.
Including interference that may cause undesired operation.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Waste electrical and electronic products
must not be disposed of with household
waste. Please recycle where facilities
exist. Check with you Local Authority or
Retailer for recycling advice.
19216811.live