Archer C20

AC750 Wireless Dual Band Router

- 19 -



Region

-

Select your region from the drop-down list. This field specifies the region

where the wireless function of the router can be used. It may be illegal to use the

wireless function of the router in a region other than one of those specified in this field. If

your country or region is not listed, please contact your local government agency for

assistance.



Note:

Limited by local law regulations, version for North America does not have region

selection option.



Security



Enable Security (WPA-PSK/WPA2-PSK) –

It’s selected by default, with the

default PSK password the same as the default PIN code.



Disable Security -

The wireless security function can be enabled or disabled. If

disabled, the wireless stations will be able to connect the router without encryption.

The above settings are only for basic wireless parameters. For advanced settings, please

check “

More Advanced Wireless Settings

”, and then you can set the following parameters.



Band -

This field displayed the operating frequency being configured.



Mode -

This field determines the wireless mode which the router works on.



11an mixed -

Select if you are using both 802.11a and 802.11n wireless clients.



11a/n/ac mixed

– Select if you are using 802.11a, 802.11n and 802.11ac wireless

clients.



Channel Width -

Select any channel width from the drop-down list. The default setting

is “Auto”, which can adjust the channel width for your clients automatically.



Channel -

This field determines which operating frequency will be used. It is not

necessary to change the wireless channel unless you notice interference problems with

another nearby access point. If you select “Auto”, then the AP will select the best

channel automatically.

Archer C20

AC750 Wireless Dual Band Router

- 20 -

8.

Confirm the parameters and click the

Save

button to make the settings take effect.

Figure 3-15 Quick Setup - Confirm

9.

Click the

Finish

button to complete the

Quick Setup

.

Figure 3-16 Quick Setup - Finish

Archer C20

AC750 Wireless Dual Band Router

- 21 -

Chapter 4. Configuring the router

This chapter will show each key function of the Web page and its configuration method.

4.1

Login

After your successful login, you will see the main menus on the left of the Web-based utility. On the

right, there are the corresponding explanations and instructions.

The detailed explanations for each key function are listed below.

4.2

Status

The Status page provides the current status information about the router. All information is

read-only.

Archer C20

AC750 Wireless Dual Band Router

- 22 -

Figure 4-1 Status

Archer C20

AC750 Wireless Dual Band Router

- 23 -

4.3

Quick Setup

Please refer to

3.2 Quick Installation Guide

.

4.4

Network

Figure 4-2 the Network menu

There are three submenus under the Network menu (shown in Figure 4-2):

WAN

,

LAN

and

MAC

Clone

. Click any of them, and you will be able to configure the corresponding function.

4.4.1

WAN

Choose menu “

Network

→

WAN

”, you can configure the IP parameters of the WAN on the

screen below.

1.

If your ISP provides the DHCP service, please choose

Dynamic IP

type,

and the router will

automatically get IP parameters from your ISP. You can see the page as follows (Figure

4-3):

Figure 4-3 WAN – Dynamic IP