16

ETH interface

The ETH WAN Interface Configuration window enables you to add, delete, or modify up to one

ETH WAN Layer 2 interface connections.

Click

ETH Interface

in the Layer2 Interface menu to open the ETH WAN Interface

Configuration window

ETH WAN Configuration

If you have selected to add or modify an ETH interface connection, the ETH WAN

Configuration window opens

17

WAN Service

To access the

Wide Area Network (WAN) Service Setup

window, click the

WAN Service

button in the

Advanced Setup

directory.

This window is used to configure the

WAN interface. You can add and delete WAN interface

on this window.

If you are setting up the WAN interface for the first time, click the

Add

button.

The

WAN Service Interface Configuration

Configuration window allows select a layer 2

interface for this service.

Click the

Next

button to continue

This window allows you to select the appropriate connection type. The choices include PPP

over ATM (PPPoA), PPP over Ethernet (PPPoE), IP over Ethernet (IPoE), IP over ATM (IPoA),

and Bridging.

WAN Service Configuration – PPPoE

Click the PPP over Ethernet (PPPoE) radio button on this window. This window also allows

you to use the drop-down menu to enable IPv6 service. Click the

Next

button to continue.

18

WAN Service Configuration – PPPoE

This window allows you to set the username and the password for your PPP connection. This

information is obtained from your ISP. Additional settings on this window will also depend on

your ISP. And you can input 2

nd

IP on this page. Click the

Next

button to continue.

19

WAN Service Configuration –

IPoE

This window allows you to configure the WAN IP settings. This information is obtained from

your ISP. Click the

Next

button to continue

20

WAN Service Configuration – Bridging

Click the Bridge radio button on this window. Click the

Next

button to continue.