Page 11 / 44
Scroll up to view Page 6 - 10
11
3.
SETTINGS WIZARD
With wizard setting steps, you could configure the router in a very simple way.
This configuration wizard includes settings of
a.
Login Password,
b.
WAN Setup
c.
Wireless Setup,
Press “Next” button to start configuration.
Step 1: Allow you to change the system password.
It is recommended that you change the system password into the one
you prefer to on the basis of security
•
Key in your Old Password (if it is the first initiation, the “admin” will be
the defaulted one.
•
Enter your New Password
•
Enter your Password again for confirmation; it must be the same as the
New Password.
-> Next
Page 12 / 44
12
Step 2
Select WAN Types will be used for Internet connection
-> Next
Step 3
If chosen 3G, configure the 3G settings
•
APN: Enter the APN for your PC card here.
•
Pin Code: Enter the Pin Code for your PC card
•
Dialed Number: This field should not be altered except when required
by your service provider.
•
Username: Enter the new Username for your PC card here.
•
Password: Enter the new Password for your PC card here.
•
Primary DNS: This feature allows you to assign a Primary DNS
Server
Optional
•
Secondary DNS: This feature allows you to assign a Secondary DNS
Server
Optional
•
Maximum Idle Time: The Connection will be broken when the idle time
arrives.
-> Next
Page 13 / 44
13
Step 3
If chosen Flash-OFDM, configure the Flash-OFDM settings
•
LAN IP-address: Can be modified if necessary.
-> Next
Step 3
If chosen WAN Ethernet port, configure the WAN settings
Choose ”Obtain an IP address from ISP automatically”
-> Next
•
LAN IP Address: The IP address of the LAN interface. The default IP
•
Host Name is optional
•
WAN’s MAC Address: If you click the Clone MAC button, you will find the
MAC address of your NIC shown in WAN's MAC Address.
Note: Do not
modify this, if not necessary!
-> Next
Page 14 / 44
14
Step 4: Configure the wireless settings.
•
Select Enabled or Disabled. The default setting is Enabled.
•
Network ID (SSID) will be as a default TW-3G_ofdm_router.
It is
recommended that you change the SSID for making it easier to identify.
•
Channel:
The channel selection is at auto by default, which means that
your router will automatically choose the channel with least traffic.
If
necessary, you might pick a specific channel.
•
-> Next
Page 15 / 44
15
Step 5: Select the Wireless security method of your wireless configuration.
•
Security: Security type for your wireless connection.
The secirity is
disabled by default, but is very strongly recommended to enable it.
•
WPA-PSK or WPA2-PSK are recommended.
They perform better than
WEP.
Note: your computer’s network card must support the chosen
security type.
•
WPA-PSK / WPA2-PSK: Choose encryption type, TKIP tai AES. With
WPA-PSK you should choose TKIP-encryption, with WPA2-PSK-you
shoudl choose AES-encryption. The password lenght is 6-63 letters or
numbers.
•
WEP: Choose between 64 / 128 bits, and hexadecimals / ASCII
64 bits + HEX= 10 numbers
128 bits + HEX= 26 numbers
64 bits + ASCII= 5 letters or numbers
128 bits + ASCII= 13 letters or numbers
Type your password in ”Key 1” slot.
-> Next
19216811.live