xii.

Once the Wizard has auto-detected the settings, you’ll be greeted with screen below. Tap on [Finish] to finalize the configuration.

xiii.

If the Almond fails to auto-detect the type of internet connection you are using, you’ll be greeted with the following screen instead.

xiv.

If you’re uncertain about the type of internet connection you have, please select [Not sure] and tap next.

xv.

Follow the on-screen instructions on how to restart your modem.

xvi.

If this step fails, then please go back and try to manually configure your internet connection selecting one of the other three options. For more

detailed instructions on how to configure your Almond to work with a DHCP or Cable modem connection, please see section 3.1, a DSL Dialup

service, please see section 3.2 and for manual IP configuration, please see section 3.3.

16

3.1 Using your Almond with a DCHP or Cable modem connection

If your internet provider has specified that your internet connection uses DHCP (Dynamic Host Configuration Protocol), or if your internet connection

uses a Cable modem, then the following steps should be taken to get your Almond connected to the Internet.

i.

Select DHCP or Cable Modem from the menu on the screen and tap [Next] to continue.

17

ii.

Please follow the on-screen instructions of your Almond for this step. It’s important that you follow these instructions or your Almond might not

be able to connect to your modem. Once you’re done, please tap [Next] to continue and wait for the DHCP settings to be automatically detected

and saved.

18

iii.

If you see a green square in front of the word Connected your Almond is now configured properly and is ready to be used. Please take note of

the Almond wireless name (SSID) and password at this point. Tap on [Finish] to save the settings and finalize the configuration.

Note:

You can

always find your wireless network SSID and password by tapping on the Wireless icon on your Almond.

19

If you connect to the internet via an xDSL connection, then follow these steps to configure your Almond to connect to the internet through your

modem. Note that the Almond does not support PPPoA ADSL connections.

i.

Select DSL Dialup from the menu on the screen, a notice will appear on the screen, tap it to close it and then tap [Next] to continue.

ii.

Enter your dial-up username and password provided by your ISP (Internet Service Provider), and tap [Done] and then [Finish]. Your Almond will

save the settings which will take a few seconds.

20

3.2 Using your Almond with an xDSL modem