M S I R G 3 0 0 E X （ L i t e )

6. Choose ‘Use a 128 bit key’ and click ‘Next’.

Fill in a password in the field ‘Network Key’. For this WEP key you are only allowed to use numbers

from 0 till 9 and the letters a till f. Do not use any punctuation marks and make sure the password is

exactly 26 characters long.

7. Write down the network name and the chosen password**.

Page 35 of 52

M S I R G 3 0 0 E X （ L i t e )

8. Click ‘Next’.

9. Click ‘Finish’.

Page 36 of 52

M S I R G 3 0 0 E X （ L i t e )

The wizard will now save the settings and will close the screen automatically.

Finishing the installation procedure of your Access Point

After following chapter 4, you can finish the installation procedure:

1. Remove the UTP network cable from your computer.

2. Remove the UTP networking cable from the LAN port of your RG300EX

（

Lite).

3. Restart your computer.

4. Congratulations! You have now properly installed the RG300EX

（

Lite).

An explanation how to connect your wireless network using Windows XP and

Windows Vista can be found in chapter

4.0 Configuring the RG300EX

（

Lite) as a signal booster

Do you already have a wireless network and do you like to increase the range of the wireless signal? Then

connect the RG300EX

（

Lite) as a signal booster. In order to realize this, several settings of your signal

booster (2) and of your wireless router / access point (1) must be modified.

A 2nd RG300EX

（

Lite) as signal repeater

4.1 Connecting the RG300EX

（

Lite) signal booster (2)

1. Turn off your computer.

2. Connect the RG300EX

（

Lite) to a wall outlet using the supplied power adapter.

3. Connect the supplied UTP network cable to the ‘LAN 1’ port of the RG300EX

（

Lite).

4. Connect the other end of the UTP network cable to the network adapter of your computer.

Is my RG300EX

（

Lite) correctly connected to the wall outlet? You can check this by verifying that the

POWER LED is on.

Page 37 of 52

M S I R G 3 0 0 E X （ L i t e )

4.2 Configuring the RG300EX

（

Lite) signal booster (2)

1. Turn on your computer.

2. Open your internet browser (e.g. Internet Explorer, Netscape of Firefox).

3. Type ‘

’ in the address bar.

4. You will now be asked for a ‘Username’ and a ‘Password’. Fill in ‘admin’ in the

‘

Username’ field and

‘admin’ in the ‘Password’ field and press the enter key.

5. The login screen is shown.

6. Click ‘Network’ in the left menu.

Page 38 of 52

M S I R G 3 0 0 E X （ L i t e )

7. Click ‘LAN/DHCP Server’.

8. Select ‘Stop’ at ‘DHCP Server’.

9. Click ‘Apply’ at the right side in the menu ‘DHCP Server’.

10. Type ‘192.168.0.200’ in the ‘LAN IP address’ field.

11. Type ‘255.255.255.0’ in the ‘Subnet mask’ field.

12. Click the button ‘Apply & Restart’.

Note! If you wish to log in to your RG300EX

（

Lite) at a later point in time, you must assign a fixed IP

address to your computer.

1. Click ‘Start’.

2. Double click ‘Network Connections’.

Page 39 of 52