21

ARP Table

The ARP Table screen displays all of the IP-to-physical address translation entries

recorded in your router.

22

Advanced Configuration

The Advanced Configurations are available under the

Advanced Setup

tab.

Connection Mode

This router supports two connection modes: DSL mode and Ethernet mode. Select DSL

mode, if you access Internet through telephone line and Ethernet mode through network

cable. By default, system is in DSL mode.

To enter the connection mode interface, click “

Advanced Setup”

---

“Co

nnection

Mode

”.

Select a proper connection mode and then click the “

Apply

” button.

23

WAN Service

In DSL mode, you are required to configure parameters for ATM interface.

To enter the ATM Interface page, click “

Advanced Setup

”

---

“

Connection Mode

” (Select

DSL mode and click “

Apply

”)

---

“

WAN Service

”

---

ATM Interface. And then click “

Add

”

to configure the relevant parameters.

On this page, you can configure VPI and VCI values (consult your local ISP if you are not

clear). For other options, keep the defaul

ts and click the “

Apply/Save

” button.

Below

you find details on the parameters.

Field

Description

VPI/VCI

Enter the PVC identifier (VPI and VCI) provided by your ISP.

DSL Link Type

Select the DSL link type for the connection. Your ISP should inform you

which type to use.

Connection

Mode

Select the connection mode according to your application.

Encapsulation

Mode

Select the encapsulation mode for the connection. Your ISP should

inform you which mode to use.

Service

Category

Select the encapsulation mode for the connection. If you are not sure

which type to select, just use the default type.



UBR without PCR

: This service mode does not provide assurance

about the cell latency, the bit loss rate, etc. it is a best-effort

service.



UBR with PCR/ CBR

: This service mode provides constant rate

24

service. It is the idea service for timely and fixed bandwidth.



Non Realtime VBR/ Realtime VBR

: This service mode provides

assurance such as latency and bit loss rate and is often

associated with video and time sensitive service. None Realtime

VBR allows more time delay than Realtime VBR.

IP QoS

Scheduler

Algorithm

Select the schedule algorithm for IP QoS.



Strict Priority

: Always sends the packets with the highest priority.

The default value 8 is the lowest precedence.



Weighted Fair Queuing

: It is an automatically bandwidth

adjusting method, sharing the available bandwidth when

congestion happens. The bandwidth is assigned according to the

priority and the weight value. You can set the weight value from 1

to 63, and 63 is the highest weight value.

The precedence

identification range is from 1 to 8, and the highest precedence is 1.

Please refer to

Quality of Service

->

Queue Config

section for

more information.

LAN

The LAN section changes the settings on the network connec

ted to the Router’s Ethernet

ports.

Enable IGMP Snooping: Check/uncheck to enable/disable the IGMP Snooping

DHCP Settings / Server

This router enables DHCP server function by default. DHCP refers to Dynamic Host

Control Protocol. With an internal DHCP server, the Router can automatically configure

the IP addresses, subnet mask, gateway and DNS server, etc for the computers that

connect to the router’s LAN ports and are configured to obtain an IP address

automatically. Therefore it reduces the inconvenience and trouble in manually configuring

IP address and other network parameters for multiple computers in LAN.

25

Enter

the desired settings and click

Apply/Save

to activate the new IP settings.

Note:

I you have changed the settings of your LAN you need to adapt the connected

devices with the new LAN Settings to access the Internet.