R90 Series

16

4.4

System Settings

From the system settings page you can perform a variety of administration tasks.

Set Password – From here you can change the password which is used to access the web GUI

Set Username – This option allows you to modify the user name which is used to access the web GUI

Management Interface Protocol – This option allows you to toggle between using a HTTP or HTTPS

connection when using the web GUI.

If you do change to using a HTTPS connection please ensure that

you add in HTTPS in the address field of your browser

Restore Settings – This option will restore the unit to factory settings. Any modifications that you may

have mad to SSID, WPA password, Port Forwarding etc will be lost.

The login will revert back to the

default settings.

Router Upgrade – Occasionally your operator may release a new firmware for your R90, and this new

firmware can be applied using this option

Reboot Settings – Occasionally you may need to reboot your device and this can be done by using this

option.

R90 Series

17

4.5

Advanced Wireless Settings

From this page you can enable / disable your WiFi, as well as decide whether to broadcast your SSID.

If

you would like to disable access to the web interface via WiFi you can un-check the ‘Enable Access to

Router Management via Wi-Fi’ checkbox.

From this page you can also configure which devices are allowed to connect to your R90.

If at anytime

you would like to see which devices are connected to your R90 then you can simply press the WiFi Clients

table button and this will display a complete list

R90 Series

18

4.6

Multi Port Forwarding

Clicking on the “Multi Port Forwarding” sub-heading in the “Advanced” list will take you to the relevant

page. Multi Port Forwarding allows you to route a range of ports to the devices that are connected to your

router. Your internal computers are protected by a firewall, so computers that are outside your network

cannot “see” or reach your computers.

4.6.1

Multi Port Forwarding

To enter settings into Port Forwarding, first select the appropriate service from the “Protocol” drop-down

box. Select an application, enter the IP address and port number for your internal server into the provided

spaces, and click “Apply”. Note: Opening ports in your firewall can pose a security risk. You can enable

and disable settings very quickly. It is recommended that you disable these settings when you are not

using a specific application.

R90 Series

19

4.7

Single Port Forwarding

This feature helps forward IP packets from a specific port to a specific host in your LAN by changing the port

number.

R90 Series

20

4.8

Firewall

This page will allow you to enable / disable your firewall