Select the mode your ENHWI-N3 is going to use. The Setup Wizard will skip the

WAN configuration under

AP Repeater Mode

.

Click

and your ENHWI-N3 will automatically detect your “Internet” Network

settings.

21

The Smart Wizard will detect the DHCP and PPPoE connections automatically. In

the picture above it shows that the Smart Wizard detected a DHCP server. You can

choose the detected service type or select

“Others”

to setup the WAN settings

manually.

22

Here, you can configure the host name and MAC address of the ENHWI-N3. The

“

Clone MAC Address”

button clones the MAC address of your PC and use it as the

MAC address of your ENHWI-N3 router instead of the real MAC address of the

router.

The Smart Wizard has finished setting up the

WAN Configuration

portion. Click

to proceed to other portions.

23

Setting up Wireless LAN

Enter the name for your wireless network SSID (the default is ENCORE59FE74) and

security key (default is 1234567890). Move and point your mouse over to the

security level blocks from the weakest (red block) to the strongest (green block), and

click on the selected block to select the level of security you desired. The “Key” type

will depend on the wireless security you selected. If you choose WEP as the wireless

security you will be prompted whether an ASCII or Hexadecimal is your preferred key

type. Hexadecimal requires 10 character digits on the KEY: field.

Click

to proceed

24

To save configuration changes click

NOTE:

After the Wireless settings are saved and the ENHWI-N3 is rebooted, you

need to reconnect your WLAN client using the new security settings you just

changed. You will need to reenter the new wireless security key for the client

and the ENHWI-N3 reestablish wireless connections.

25