Page 36 / 108 Scroll up to view Page 31 - 35
ENHWI-2AN3 User’s Manual
Encore Electronics Inc.
Tel – (626) 336-4567
Fax – (626) 336-2345
Web Site – www.encore-usa.com
36
Monitor Tab
This screen shows the histogram of the network connection on WAN, LAN &
WLAN. Auto refresh keeps information updated frequently.
Page 37 / 108
ENHWI-2AN3 User’s Manual
Encore Electronics Inc.
Tel – (626) 336-4567
Fax – (626) 336-2345
Web Site – www.encore-usa.com
37
Language Tab
This is where you select preferred language.
Page 38 / 108
ENHWI-2AN3 User’s Manual
Encore Electronics Inc.
Tel – (626) 336-4567
Fax – (626) 336-2345
Web Site – www.encore-usa.com
38
WIZARD
Click
Wizard
to configure the basic functionalities of the ENHWI-2AN3 Router. A
popup Setup Wizard Window will be immediately displayed. If the popup window for
Setup Wizard failed to appear check your Popup Settings and make sure popup is
allowed at least temporarily for this purpose. Before you continue, check all the
needed cables if they are properly hooked up. Check your DSL or Cable Modem if
working properly and is connected to your ISP and then click
<Next>.
Refer to the
Smart Wizard
section for more details
.
INTERNET
Page 39 / 108
ENHWI-2AN3 User’s Manual
Encore Electronics Inc.
Tel – (626) 336-4567
Fax – (626) 336-2345
Web Site – www.encore-usa.com
39
-
Status
This page shows the current Internet connection type and status
-
Dynamic IP
Use the MAC address when registering for the Internet service, and do not change
it unless required by your ISP. If your ISP use the MAC address of the Ethernet
card as an identifier, connect only the PC with the registered MAC address to the
broadband router and click the
<Clone MAC Address>
button. This will replace
the current MAC address with the already registered Ethernet card MAC address
.
Page 40 / 108
ENHWI-2AN3 User’s Manual
Encore Electronics Inc.
Tel – (626) 336-4567
Fax – (626) 336-2345
Web Site – www.encore-usa.com
40
Host Name:
This is optional.
MAC address:
The default value is set to the WAN’s physical address or MAC of
the broadband router.
- Static IP
If your ISP Provider has assigned a fixed public IP address for you to use, enter the
assigned IP address, Subnet Mask, Default Gateway IP address, Primary and
Secondary DNS (if available) of your ISP provider.

Rate

4.5 / 5 based on 2 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top