Vigor2710 Series User’s Guide

9

Interface

Description

WLAN

Press the button once to enable (WLAN LED on) or

disable (WLAN LED off) wireless connection.

DSL

Connector for accessing the Internet through ADSL2/2+.

LAN (1-4)

Connectors for local networked devices.

USB

Connector for USB storage (Pen Driver/Mobile HD) or

printer.

Interface

Description

Line

Connector for PSTN life line.

Phone

Connector of analog phone for VoIP communication

.

Factory Reset

Restore the default settings. Usage: Turn on the router (ACT LED is blinking). Press the

hole and keep for more than 5 seconds. When you see the ACT LED begins to blink

rapidly than usual, release the button. Then the router will restart with the factory default

configuration.

PWR

Connector for a power adapter.

ON/OFF

Power Switch.

Vigor2710 Series User’s Guide

10

1.3 Hardware Installation

Before starting to configure the router, you have to connect your devices correctly.

1.

Connect the ADSL interface to the external ADSL splitter with an ADSL line cable for

all models. For Vigor2710Vn/VDn, also connect Line interface to external ADSL

splitter.

2.

Connect one end of an Ethernet cable (RJ-45) to one of the

LAN

ports of the router and

the other end of the cable (RJ-45) into the Ethernet port on your computer.

3.

Connect the telephone sets with phone lines (for using VoIP function). For the model

without phone ports, skip this step.

4.

Connect one end of the power adapter to the router’s power port on the rear panel, and

the other side into a wall outlet.

5.

Power on the device by pressing down the power switch on the rear panel.

6.

The system starts to initiate. After completing the system test, the

ACT

LED will light

up and start blinking.

Here, we take

Annex A

model as an example for describing hardware installation.

Vigor2710 Series User’s Guide

11

Caution

:

1. Each of the Phone ports can be connected to an analog phone only. Do not connect

the phone ports to the land line jack. Such connection might damage your router.

2. When the power is shutdown, VoIP phone will be disconnected. However, a phone

set connected to Phone 2 port can be used as the traditional telephone for the line will

be guided to land line jack via the router (loop through).

1.4 Printer Installation

You can install a printer onto the router for sharing printing. All the PCs connected this

router can print documents via the router. The example provided here is made based on

Windows XP/2000. For Windows 98/SE/Vista, please visit

www.draytek.com

.

Before using it, please follow the steps below to configure settings for connected computers

(or wireless clients).

1.

Connect the printer with the router through USB/parallel port.

2.

Open

Start->Settings-> Printer and Faxes

.

3.

Open

File->Add a New Computer

. A welcome dialog will appear. Please click

Next

.

Vigor2710 Series User’s Guide

12

4.

Click Local printer attached to this computer and click Next.

5.

In this dialog, choose

Create a new port Type of port

and use the drop down list to

select

Standard TCP/IP Port

. Click

Next

.

Vigor2710 Series User’s Guide

13

6.

In the following dialog, type

192.168.1.1

(router’s LAN IP) in the field of

Printer

Name or IP Address

and type

IP_192.168.1.1

as the port name. Then, click

Next

.

7.

Click Standard and choose Generic Network Card.

8.

Then, in the following dialog, click

Finish

.