DG-BR4015N User Manual

26

2-2-4 Windows Vista IP address setup

1. Click ‘Start’ button (it should be located at lower-left corner of your

computer), then click control panel. Click on ‘View Network Status and

Tasks’ and then click on ‘Manage Network Connections’. Right-click

‘Local Area Connection’, then select ‘Properties’. Local Area

Connection Properties window will appear, select ‘Internet Protocol

Version 4 (TCP / IPv4), and then click ‘Properties’

DG-BR4015N User Manual

27

2. Select ‘Use the following IP address’, then input the following

settings in respective field:

IP address: 192.168.2.2

Subnet Mask: 255.255.255.0

Default gateway: 192.168.2.1

Click ‘OK’ when finish.

DG-BR4015N User Manual

28

2-3 Accessing router’s web GUI

After you assign an IP address to the computer, open the web browser (Internet Explorer

5.x or above, Firefox, or Netscape) and type the IP address of router in the address bar as

‘http://192.168.2.1’ and hit ‘Enter’ to establish connection.

You should see the following authentication window:

Please input user name and password in the field respectively, default user name is

‘admin’, and default password is ‘admin’, then press ‘OK’ button to enter into web

management interface of this router:

DG-BR4015N User Manual

29

Following is the Web GUI interface of the router.

NOTE: If you can’t see the web management interface, and you’re

being prompted to input user name and password again, it means

you didn’t input username and password correctly. Please retype

user name and password again. If you’re certain about the user

name and password you typed please go to Troubleshooting

section to perform a factory reset to set the password back to

default value.

TIP: This page shows the eight major setting categories: Wizard,

Internet Mode (3G), Network, Wireless, Firewall, Advance,

Management, Status. You can jump to another category directly

by clicking the link.

DG-BR4015N User Manual

30

2-4 Using Router Setup Wizard

This router provides a ‘Quick Setup Wizard’ procedure, which will help you to complete

all required settings you need to access the Internet quickly. Please follow the instructions

mentioned below to complete the ‘Quick Setup’:

Please go to Quick Setup menu by clicking

‘Wizard’

button. And the following window

will be displayed: