DG-BG4300N User Manual

2. System and Network Setup

2.1 Hardware Installation

Step 1

Connect the

Line

interface of the device and the

Modem

interface of the splitter with a

telephone cable. Connect the phone set to the

Phone

interface of the splitter through a

telephone cable. Connect the input cable to the

Line

interface of the splitter.

Step 2

Connect all your computers, network devices (switch / hub) to the LAN port of the

router.

DG-BG4300N User Manual

Step 3

Connect the power adapter (9V DC / 1A) to the wall socket, and then connect it to the ‘Power’

socket of the router.

Step 4

Please check all LEDs on the front panel. Power LED ‘should be steadily ON, ADSL and LAN

should be ON. Check if the computer / network device connected to the respective port of the

router is powered ON and co

rrectly connected. If power LED ‘P’ is not ON, or any LED you

expected is not ON, please recheck the cabling.

DG-BG4300N User Manual

3. Software Installation

Step 1

: Insert the Setup CD into your CD-ROM drive of notebook/desktop computer.

Step 2

: You will see the Autorun utilit. Click ‘

Start

’ to continue.

DG-BG4300N User Manual

Step 3

: Connect one end of the telephone cable RJ-11 into the ADSL port provided on the splitter

from the service provider and connect other telephone cable from the splitter to the LINE port on the

router. Click ‘

Next

’ to continue.

DG-BG4300N User Manual

Step 4

: Power ON the router. It will take approximately 30 seconds for router to boot up completely.

Ensure that all the LED’s on the router are ON. If not, try the above steps again else click ‘

Next

’ to

continue.

Step 5

: Connect one end of the network cable to one of the LAN ports (1~4) of the router and the other

end to your computer. Click ‘

Next

’ to continue with the installation.

Step 6

: On this page, you can view the description of LED indicators.