Page 11 / 30
Scroll up to view Page 6 - 10
WLUSB2GO
Manual
10
User can use corega Wireless Utility to configure wireless net-
work. After finishing configuration, please check if the connec-
tion works.
Please confirm that user’s computer is in the wireless radio wave
range. If the computer is out of the radio range, the setup will
not be seccessful.
After user installed CG-WLUSB2GO and corega Wireless Utility,
CG-WLUSB2GO will automatically link with the AP/Router. If the
connection is successful, the following message will appear .
1. Click the
icon in the system tray to open the Utility. If there
is no such icon, enter [Start]->click[Program]->select[CG-
WLUSB2GO]->click[corega Wireless Utility] and the icon will
appear.
2. The available APs are displayed in the [Site Survey] tab. If there
is no AP in dialog box, please press [Rescan] .
4
Setting Wireless Network
Page 12 / 30
WLUSB2GO
Manual
11
3. To make connection, select one AP/SSID (eg:corega) and
click [Conncet].
When the connection works, [Connected]
will appear in the left button of this tab and the
icon
appears in front of the linked AP.
When the connection
failed,[Disconnected] will appear.
If the AP has set up the encryption, please setup the the same
keys on CG-WLUSB2GO (refer to chapter 5) before you click
[OK].
Page 13 / 30
WLUSB2GO
Manual
12
If your AP/Router have set network security function, your
wireless adapter needs to have the same security setting. The
details of network security setting are described below. Please
open corega Wireless Utility before you start to setup network
security:
Double click the
icon in the system tray to open the Utility
page. If there is no wireless icon, please click [start Menu]->se-
lect [Programs]->click [CG-WLUSB2GO]->click [corega Wireless
Utility], and the wireless icon will appear.
5.1 Setting WEP
1.
If your AP has [WEP] authentication(eg:corega ), press [Con-
nect].
5
Network Security Setting
Page 14 / 30
WLUSB2GO
Manual
13
2. Please follow the instructions:
a. [Authentication Type]: indicates the authentication type of
the AP/Router. Please confirm the setting of the AP/Router.
＊
[Open]: WEP open system is based on request and grant. It is
essentially no authentication.
＊
[Shared]: WEP shared key is based on request, challenge, challenge
response, grant/deny.
b. Select
[WEP] in [Encryption].
c. Enter AP encryption keys(64/128bits) in the box Key1~Key4.
Please accept the auto selected setting of [Hex]/[ASCII].
d. Select the current AP encryption keys from Key1~Key4.
e. Press [OK] to finish setting.
Page 15 / 30
WLUSB2GO
Manual
14
5.2 Setting WPA
WPA encryption type can be divided into WPA-PSK, WPA2-PSK,
WPA(or called WPA-EAP), and WPA2(or called WPA2-EAP). All
settings should correspond to the settings of the current con-
nected wireless network.
《
WPA-PSK and WPA2-PSK
》
1.
Select an AP with [WPA-PSK] or [WPA2-PSK] authentication
and press [Connect]. Here we use corega A for example. Thus
the following settings must correspond with corega A.
2. Setting the [Authentication and Security] Page:
19216811.live