11

4

USB LED (Blue)

On:

A USB drive is connected.

Blinking:

The USB drive can be removed.

Note:

When this LED is blinking, the connected USB drive cannot be used. Remove the connected USB drive. If the

LED continues to blink even after the USB drive is removed, restart the AirStation. Do not remove the USB drive or

turn off the AirStation while the USB LED is on.

5

USB 3.0 Port

You can connect any USB 3.0 compatible devices (such as USB storage). Use the cable attached to the USB 3.0

device to connect.

6

USB 2.0 Port

You can connect any USB 2.0 compatible devices (such as USB printers).

7

LAN Port

Connect your computer, hub, or other Ethernet devices to these ports. This switching hub supports 10 Mbps, 100

Mbps, and 1000 Mbps connections.

8

LAN LED (Green)

On:

An Ethernet device is connected.

Blinking:

An Ethernet device is communicating.

9

Internet Port

10 Mbps, 100 Mbps, and 1000 Mbps connections are supported.

Note:

In wireless bridge mode or access point mode, the Internet port becomes a regular LAN port, for a total of 5

usable LAN ports.

10

Internet LED (Green)

On:

The Internet port is connected.

Blinking:

The Internet port is transmitting data.

11

Power button

This button turns the power on and off.

It may take 20 to 30 seconds to complete shutdown.

12

DC connector

Connect the included AC adapter here.

12

Bottom

1

Reset button

To reset all settings, hold down this button until the Buffalo LED turns red (about 3 seconds). The power must be

on for this to work.

2

Setup card slot

This is the slot where the AirStation setup card is stored. The initial settings for the username, password, SSID, and

encryption type are provided on the card for logging into

Settings.

Right Side

1

Mounting holes

Mounting holes are provided for mounting the AirStation to a wall. Use the supplied screws to mount to a wall.

13

Vertical Placement

Attach the stand as shown in the figure below.

Horizontal Placement

The same stand also allows horizontal placement. Install the stand as shown in the figure below.

14

Wall-Mounting

Attach to the wall with the supplied screws in the mounting holes as shown below.

15

Connect to a PC and Power On

To configure your AirStation, follow the procedure below.

1

Verify that you can connect to the internet without the AirStation, then turn off your modem and computer.

2

Unplug the LAN cable which connects your computer and modem.

3

Plug one end of the LAN cable into your modem and the other end to the AirStation’s Internet (WAN) port.

Turn on

the modem.