Configuring PC in Windows 98/Me

1

.Go to

Start / Settings / Control Panel

.

In the Control Panel, double-click on

Network

and choose the

Configuration

tab.

2.

Select

TCP/IP ->NE2000 Compatible

,

or the name of your Network Interface

Card (NIC) in your PC.

3.

Select the

Obtain an IP address

automatically

radio button.

4.

Then select the

DNS Configuration

tab.

5.

Select the

Disable DNS

radio button

and click

OK

to finish the configuration.

14

Configuring PC in Windows NT4.0

1.

Go to

Start / Settings / Control Panel

.

In the Control Panel, double-click on

Network

and choose the

Protocols

tab.

2.

Select

TCP/IP Protocol

and click

Properties

.

3.

Select the

Obtain an IP address from a

DHCP server

radio button and click

OK

.

15

3.2 Factory Default Settings

Before configuring your, you need to know the following default settings.

Web Interface:

Username: admin

Password: admin

LAN Device IP Settings:

IP Address: 192.168.1.254

Subnet Mask: 255.255.255.0

ISP setting in WAN site:

PPPoE

DHCP server:

DHCP server is enabled.

Start IP Address: 192.168.1.100

IP pool counts: 100

3.2.1 Username and Password

The default username and password are “

admin

” and “

admin

” respectively.

Attention

Attention

If you ever forget the password to log in, you may press the RESET

button up to 6 seconds to restore the factory default settings.

16

3.3 LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory.

The default values are

shown below.

IP address

192.168.1.254

Subnet Mask

255.255.255.0

DHCP server function

Enabled

IP addresses for

distribution to PCs

100 IP addresses continuing from

192.168.1.100 through

192.168.1.199

The PPPoE function is

enabled

to

automatically get the

WAN port

configuration from the

ISP, but you have to

set the username and

password first.

3.4 Information from your ISP

Before configuring this device, you have to check with your ISP (Internet Service Provider)

what kind of service is provided such as PPPoE, PPPoA, RFC1483, or IPoA.

Gather the information as illustrated in the following table and keep it for reference.

VPI/VCI, VC-based/LLC-based multiplexing, Username, Password,

Service Name, and Domain Name System (DNS) IP address (it can

be automatically assigned by your ISP when you connect or be set

manually).

VPI/VCI, VC-based/LLC-based multiplexing, Username, Password,

and Domain Name System (DNS) IP address (it can be

automatically assigned by your ISP when you connect or be set

manually).

VPI/VCI, VC-based/LLC-based multiplexing to use Bridged Mode.

VPI/VCI, VC-based/LLC-based multiplexing, IP address, Subnet

mask, Gateway address, and Domain Name System (DNS) IP

address (it is fixed IP address).

17

3.5 Configuring with your Web Browser

Open your web browser, enter the IP address of your router, which by default is

192.168.1.254

, and click “

Go

”, a user name and password window prompt will appear.

The

default username and password are “admin” and “admin”.

Congratulation! You are now successfully logon to the BIPAC 5102 Series ADSL

Router!

18