Chapter 1 - Product Description

In This Chapter:



“Introducing the BreezeMAX PRO 6000” on page 2



“BreezeMAX PRO 6000 CPE Specifications” on page 3

BreezeMAX PRO 6000 Product Manual

Chapter 1 - Product Description

Introducing the BreezeMAX PRO 6000

2

1.1

Introducing the BreezeMAX PRO 6000

The PRO 6000 CPE comprises an Outdoor Unit (ODU) and an Indoor Unit (IDU).

The ODU includes the modem, radio, data processing, management and voice gateway components of

the Subscriber Unit (SU). It also includes an integral high-gain flat antenna. The ODU connects to the IDU

and to the user's equipment through a 10/100 BaseT Ethernet port.

The IDU is powered from the mains and connects to the ODU via a Category 5E Ethernet cable carrying

the Ethernet data between the two units, as well as power (56 VDC) and control signals to the ODU and

status indications from the ODU.

Figure 1-1: BreezeMAX PRO 6000

ODU

IDU

BreezeMAX PRO 6000 Product Manual

Chapter 1 - Product Description

BreezeMAX PRO 6000 CPE Specifications

3

1.2

BreezeMAX PRO 6000 CPE Specifications

1.2.1

General

1.2.2

WiMAX Radio

Table 1-1: PRO 6000 CPE General Specifications

Feature

Description

Flash ROM

32MB

Ethernet LAN port

One RJ-45 port

10/100 auto-sensing, auto-MDX

Channel Step Size

In 250 kHz steps

POTS

One RJ-11

Power supply

Input: Universal range 100~240VAC

Output: 56 VDC

Frequency: 50Hz to 60Hz

Current: 0.8A

WiMAX SoC

BCS5350 and Dual Core 300MHz

RF IC

BCSR-200 / Dual Band 1T/2R RFIC

RAM

64MB

Table 1-2: PRO 6000 CPE WiMAX Radio Specifications

Item

Description

Radio Type

IEEE 802.16e 2005 WAVE 2

Frequency Band

3.3 - 3.7 GHz

(range will be increased to 3.3 - 3.8 GHz in future release)

Antenna Type

Two WiMAX antennas

Channel Bandwidth

5.00, 7.00, and 10.00 MHz

Modulation Technique



Scaleable OFDMA employing Time-Division Duplex (TDD)

mechanism



PRBS subcarrier randomization



Contains pilot, preamble, and ranging modulation

BreezeMAX PRO 6000 Product Manual

Chapter 1 - Product Description

BreezeMAX PRO 6000 CPE Specifications

4

FEC Coding Rates



Up Link and Down Link: QPSK, 16 QAM, 64 QAM



QPSK and 16QAM - 1/2 and 3/4



64QAM - 1/2, 2/3, 3/4, 5/6

TPL (Transmit Power Level)

27 dBm typical (maximum)

Channel Step Size

In 250 kHz steps

Synchronization

Referenced to the WiMAX BTS Timing Module

Frequency Accuracy

MRCT Compliant

Air Interface

IEEE 802.16e Wireless MAN-OFDMA

TDD Duty Cycle (Tx/Rx)

Rx up to 75% , Tx up to 50%

SISO or MIMO

MIMO (1TX, 2RX)

Regulatory Compliance



FCC parts 15, 25, 27, 90



RSS 192, 197

Frame Duration

5 msec.

RF Transmitter Specifications

RF dynamic range

45dB minimum

Transmit Power Control Relative

Accuracy

mRCT compliant

Transmit and Receive Switching Gap

50



S

RF Receiver Specifications

Impedance

50 ohms nominal

Input return loss

10dBi

RX Sensitivity

Typical 3dB better than mRCT in SISO mode, and 6 dB better

in MRC or MIMO mode. -94.5 dBm maximum.

Adjacent Channel Rejection

4 dB min.

Receive signal 64QAM-3/4, 3dB above sensitivity level.

Non-Adjacent Channel Rejection

23 dB min

Receive signal 64QAM-3/4, 3dB above sensitivity level.

Antenna Specifications

Antenna Gain

Typical 15 dBi

Antenna Connectors

None. Embedded IPEX

Table 1-2: PRO 6000 CPE WiMAX Radio Specifications

Item

Description

BreezeMAX PRO 6000 Product Manual

Chapter 1 - Product Description

BreezeMAX PRO 6000 CPE Specifications

5

1.2.3

Power Specification

1.2.4

Environmental Specifications

1.2.5

Regulatory Specifications

Standards for all frequency bands:

Table 1-3: PRO 6000 CPE Power Specification

Item

Details

Power Consumptions

Outdoor CPE: 16W Maximum

Power Adapter

Input of 100 VAC - 240 VAC 50 Hz to 60 Hz

Power over Ethernet

56 VDC

Table 1-4: PRO 6000 CPE Environmental Specifications

Item

Details

Operating Temperature

-40°C ~ 60°C

Storage Temperature

-40°C ~ 70°C

Operating and Storage Humidity

5% - 95%

Table 1-5: PRO 6000 CPE Regulatory Specifications

Standard

Specification

Applicable to

FCC

Part 15

ODU

Part 90, Subpart Z

ETSI

ETSI EN 302 326

ODU

WiMAX

IEEE-802.16-2005.

ODU

Environmental

ETSI 300 019-2-4 Class T4.1E

ODU

ETSI 300 019-2-3 Class T3.2.

PoE (+PS)

Transportation & Storage

ETSI 300 019-2-2 Class T2.3.

ETSI 300 019-2-1 Class T1.2.

System

EU EMC

ETSI EN 301 489-1/4

System

US EMC

FCC part 15 Subpart B (Emission test)

System

Immunity

Surge (Lightning protection), ITU-T K.21

System