Page 21 / 182 Scroll up to view Page 16 - 20
PRG AV4202N
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
14
OGU 930500275-A1
Hardware Installation
1.
Connect one end of the Ethernet cable into one of the four Ethernet ports on
the rear of the Router
2.
Connect the other end of the Ethernet cable into the Ethernet Network card
of your computer
3.
Verify if the Ethernet Network card is configured as DHCP client, otherwise
configure it to remain in the same local network of the router interface (see
chapter “Setting Up Your Computer”)
FIGURE 3.
Ethernet Cable Connection
To connect the USB cable, follow the procedure according to your Operating
System:
WINDOWS
1.
Connect one end of the USB cable into the USB port of your PC
2.
Browse till
x:\USB driver
folder (where “
x
” is the CD-ROM drive unit letter);
launch the “
setup.exe
” executable (“
x:\USB driver\setup.exe
”) and follow
setup instructions
Page 22 / 182
PRG AV4202N
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Hardware Installation
OGU 930500275-A1
15
3.
The setup software will invite you to plug the other end of the USB cable into
the USB port on the rear of the Router
MAC 10.x
1.
Connect one end of the USB cable into the USB port of your PC
2.
Connect the other end of the USB cable into the USB port on the rear of the
Router. The Operating System will automatically recognize the device
FIGURE 4.
USB Cable Connection
Don’t plug the other end of the USB cable until setup software will ask you to do it.
In the case your provider will supply to you a SIP account, it will be needed to
properly connect the FXS and FXO ports. In detail you must follow these steps:
1.
Connect one end of the first phone cable into the DSL filter port identified
with a computer symbol
2.
Connect the other end of the first phone cable into the DSL port of the
Router
Page 23 / 182
PRG AV4202N
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
16
OGU 930500275-A1
Hardware Installation
3.
Connect one end of the second phone cable into the DSL filter port identified
with a phone symbol
4.
Connect the other end of the second phone cable into the WALL port of the
Router (FXO connection)
*
5.
Connect a maximum of two analog phones to the Phone 1 or Phone 2 ports
of the Router (FXS connection)
*
If your product does not include the FXO port, exclude steps 3 and 4
Page 24 / 182
PRG AV4202N
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
Hardware Installation
OGU 930500275-A1
17
FIGURE 5.
FXS connections
Connect to your PC with Ethernet or USB cables as described in the previous
steps.
Page 25 / 182
PRG AV4202N
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
18
OGU 930500275-A1
Hardware Installation

Rate

4 / 5 based on 4 votes.

Bookmark Our Site

Press Ctrl + D to add this site to your favorites!

Share
Top